- EOL
|
Attention! The product has been discontinued. Check other products incategory. |
Description
Module based on chips Atmel SAMD21 and ATA8520, allowing networkSigFox 868MHz. Equipped with aCortex-M0+. It has256 kBofFlash memory,32 kB SRAM, 8 digital pins, 7 analog inputs, 1 analog output, 12 PWM pins. MKR Fox 1200 operates with a voltage of 3.3 V. Included is anannual free subscription to the SigFox network(up to 140 messages daily)and geolocation Spot'it.
The module can be powered by battery2 x AA, 2 x AAA batteriesor from external power supply 5 V. Switching between power sources is automatic.
Tile has many connectors:
- MicroUSB
- Screw connections for battery connection
- Female pins
- Antenna connector SigFox u.FL (no antenna included)
Key features
Below are a few features that distinguish modules Arduino compared to other programmable tiles.
| Name | Description |
|---|---|
|
Installed bootloader |
Thanks to installed bootloader, for programming the device sufficient are micro usb cableandthe software from the manufacturer's website. |
|
Small size |
This version is characterized by small size: 68 x 25 mm. It has soldered male connectors from the bottom and female connectors on the top. |
|
Connection SigFox |
Arduino MKR Fox 1200 has a built-in moduleAtmel ATA8520which allows you to exchange data in the network SigFox. |
|
Serial communication |
The device supports popular communication interfaces, i.a. UART, I2C and SPI. |
|
Built-in memory |
Chip Atmel SAMD21 is clocked with a signal at a frequency of 48 MHz, has 256 KB Flash and 32 KB RAM SRAM. |
|
Supply 5 V microUSB / battery 3.7 V |
To power the Arduino, you can usea power sourcewith a voltage of 5 V with microUSB connector or use the batteries2 x AA, 2 x AAA. |
|
Built-in LED |
The connected LED on pin 6 allows debugging simple programs. |
|
First run To help you get started with the module, a manufacturer provides a user manual that applies to the installation and to the first run of the NKR FOX 1200. |
Specification
- Microcontroller: SAMD21 Cortex M0+ 32-bit
- Supply voltage of the logic part: 3.3 V
- Memory SDRAM: 32 KB
- Flash memory: 256 KB
- Frequency: 48 MHz
- Digital pins I/O: 8
- Analog inputs: 7
- Analog output 1
- PWM: 12 pins
- UART: 1
- SPI: 1
- I2C: 1
- Current on pins I/O: 7 mA
- System SigFox: ATA8520
- Frequency : 868 MHz
- Operating area: Europe
- Included no antenna
- Power: microUSB or 2 x AA or 2 x AAA
- Screw connector
- Dimensions: 68x 25 x 20 mm
|
We guarantee that all tiles marked with a symbol of Arduino, are genuine and come from the same source. As you can see by checkingthe list of authorized distributors. |
Useful links |
