DRV8835 dual - 2-channel motor driver 11V/1,2 A - Shield for Arduino - Pololu 2511

Index: PLL-02671 EAN: 5903351244848

Dual channel DRV8835 module operates with voltages from 2 V to 11 V and current up to 1.2 A per channel (max. 1.5 A). The chip can be connected directly to Arduino board.

DRV8835 dual - 2-channel motor driver 11V/1,2 A - Shield for Arduino - Pololu 2511
€9.90
€8.05 tax excl.
Waiting time: 4-6 weeks
Temporarily unavailable
PayPal payment
Manufacturer: Pololu
Compatibility: Arduino

Product description: Pololu DRV8835 - 2-channel motor controller 11V/1,2A - shield for Arduino

Module based on DRV8835 chip allows to control motors with supply voltage up to 11 V and continuous current up to 1.2 A. The controller can also withstand several seconds of current surges up to 1.5 A. The speed can be controlled using a PWM signal.


Podówjny sterownik silników w połączeniu z Arduino
Dual motor controller in connection with Arduino. Arduino can bepurchased separately.

In combination with Arduino, using specially prepared library, it is possible to easily control speed and direction of rotation of two DC motors. The shape and pinouts of the board allow direct connection with Arduino, as shown in the figures above. The circuit uses pins 7, 8, 9 and 10, the last two being PWM signal for speed control.

Compatible with Arduino

Manufacturer provides library for Arduino users.

Operating modes

The controller can operate in two modes: basic PHASE/ENABLE and advanced IN/IN. Selection is done by the MODE pin. Differences between modes are shown in tables below.

Table for PHASE/ENABLE mode MODE=1

xPHASE xENABLE xOUT1 xOUT2 Operation mode
1 PWM L PWM

Reverse speed at the speed specified:

PWM %

0 PWM PWM L

Forward speed at specified speed:

PWM %

X 0 L L Braking (outputs connected to ground)

Table for IN/IN MODE=0

xIN1 xIN2 xOUT1 xOUT2 Operation mode
0 0 OPEN OPEN Outputs disabled.
0 PWM L PWM

Reverse speed at the speed specified:

PWM %

PWM 0 PWM L

Forward speed at specified speed:

PWM %

PWM 1 L PWM

Reverse speed at specified speed:

100% - PWM %

1 PWM PWM L

Forward speed at specified speed:

100% - PWM %

1 1 L L Braking (outputs connected to ground)

Specification for Two Channel Motor Controller

  • Supply voltage: 2 V to 11 V
  • Logic part supply voltages: 2 V to 7 V
  • Continuous output current per channel: 1.2 A
  • Continuous output current when channels are connected: 2,4 A
  • Maximum instantaneous current per channel: 1.5 A
  • Maximum instantaneous current when channels are connected: 3,0 A
  • PWM frequency: up to 250 kHz
  • Protection against incorrect power supply connection
  • Works with Arduino Uno, Leonardo, Mega 2560
  • Arduino library for easy operation
  • Dimensions: 51 x 14.5 mm
  • Weight: 2.5 g (without connectors)

Included: module, screw connectors, goldpin solder strip.

Voltage to 2.0 V
Voltage from 11.0 V
Current 1.2 A
Channels 2
Package width 8 cm
Package height 9.5 cm
Package depth 0.1 cm
Package weight 0.009 kg

Be the first to ask a question about this product!

Customers who bought this product also bought:

Products from the same category: