DFRobot L298P v1.3 2-channel motor driver 35V/2A - Shield for Arduino

Index: DFR-02686 EAN: 6959420900039

Arduino overlay to control two DC motors (35V/2A). For communication it uses four Arduino pins, allows to change the speed and direction of motor rotation.

DFRobot L298P v1.3 2-channel motor driver 35V/2A - Shield for Arduino
€15.90
€12.93 tax excl.
Available
Shipping in 24 hours
PayPal payment
Manufacturer: DFRobot
Compatibility: Arduino

Description: DFRobot Motor Shield L298P v1.3 - dual channel motor controller - cover for Arduino 35V/2A.

It is a cartridge forArduinoto control two 35 V / 2 A DC motors. The system allows you to adjust the direction and speed. It uses only four Arduino outputs and can be powered from both the base plate and external source.

DFRobot Motor Shield L298P

Power supply

The module can be powered in two ways: VIN from Arduino or from a separate source connected to the PWRIN screw connector. In the first case, the voltage range depends on the Arduino base module, usually from 7 V to 12 V. Therefore it is recommended to connect an external source. In this mode you can use the whole available range from 4.8 V to 35 V. Power supply configurations allow two PWRIN jumpers - VIN, if inserted, draws power from Arduino VIN.

Motor Controller Overlay Leads

The overlay operates on the basis of a two-channel L298 motor controller. This means that the user has the possibility to connect two motors, with a maximum current consumption of 2 A for each of them. Shield uses four Arduino outputs, can work in two PWM and PLL modes. Mode selection is enabled by jumpers on top of the board.

PWM mode

Function Channel A

Channel B

Direction of rotation D4 D7
PWM speed D5 D6

PLL mode

Function Channel A Channel B
Motor lock (low state - motor stopped) D4 D7
Direction of rotation D5 D6

Specification

  • Motor supply voltage: 4.8 V to 35 V
  • The voltage of the logical outputs: 5 V (taken fromArduino)
  • Controller: Bridge H L298P
  • Number of supported motors (channels): 2
  • Maximum current per channel: 2 A
  • Speed control via PWM signal
  • The device uses Arduino leads: 4, 5, 6, 7
  • Plate dimensions: 55 x 55 mm
  • He works with:Arduino Uno, Leonardo and Mega

Package width 6.5 cm
Package height 8 cm
Package depth 2.5 cm
Package weight 0.035 kg

Be the first to ask a question about this product!

Product reviews

DFRobot L298P v1.3 2-channel motor driver 35V/2A - Shield for Arduino

5/5

Average grade

2

Customers opinion
The following opinions are collected
and verified by
an external partner Trustmate
and come from the post-purchase process.
Krzysztof 19.04.2023 Confirmed purchase Translated review
Great choice, I recommend.
Daniel L. 23.03.2022 Confirmed purchase Translated review
Cheaper version of the arduino motor shield. It works the same.

Customers who bought this product also bought:

Products from the same category: