- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: Starting set M5GO IoT - M5Stack
M5GO IoT is astarter kitcontaining aCoreseries module and6 Unit type modules: ENV II, IR, RGB, PIR, POT and HUB. Each set can be programmed using Arduino IDE,UlFlow, MicroPython. Such programming diversity greatly simplifies the programming process.
M5Stack Core development module
The M5Stack Coreis the most advanced modular platformin the M5Stack series, which operates on theESP32controller. The modular design means that theuser does not need any electronics knowledgeto connect a number of sensors and extensions. The M5Stack provides awide range of sensorsin the form ofUnitModules - ready-made solutions that are connected via aGrovecable or plugged intocompatiblemain moduleconnectors. The M5Stack Core communicates via WiFi or Bluetooth. The development module is equipped with16 MB of flash memoryand a 2" TFTdisplaywith a screen size of 320 x 240 px. There is alsoa built-in speakerand3programmable buttons.
Unit modules included in the M5GO IoT starter kit
The manufacturer provides a widerange of sensors and extensions. They can be selected individually, depending on the design and purpose. The M5GO IoT starter kit includes6basicunits:
- ENV II - temperature and humidity sensor
- IR - transmitter and receiver operating thanks to infrared technology, has a range of up to 5 m and can be used to operate TV or DVD
- RGB- RGB LED module with three separate LEDs
- PIR- motion detector based on infrared technology, with measuring range from 0 cm to 500 cm and detection angle up to 100°
- POT - angle switch with a potentiometer, allows, among other things, to adjust the volume and brightness manually
- HUB - HUB extension unit from 1 to 3 voltages
Key features of the modules
- The system based on the ESP32 type microcontroller
- Built-in speaker and buttons
- Equipped with a 320 x 240 px LCD display
- Possibility of placing a TF card with a maximum size of 16 GB
- Pull-out pins and holes
- M-Bus connector and pins
- Support via the most popular development platforms: Arduino, UlFlow and MicroPython
A set of 6 unit sensors.
Content of M5GO IoT starter kit.
Technical specifications
- Controller:
- The deal: ESP32
- Number of cores: 2
- Flash memory: 16 MB
- Clock: 240 MHz
- Bluetooth communication: yes
- WiFi communication: yes
- Display: TFT 2" 320 x 240 px
- Speaker: 1W-0928
- MIC: Analogue microphone
- Battery: 500 mAh / 3.7 V
- The antenna: 2.4 GHz 3D
- Connectors: USB C, Grove
- Operating temperature: 0°C to 40°C
- Housing material: Plastic (PC)
Set contents
- M5Stack Core
- 6 Unit type modules
- Lego overlay - 4 pieces.
- Lego connector - 12 pcs.
- Grove cable - 4 pcs.
- USB cable type C
