- Reduced price
Product Description: Holding electromagnet 12V 10W 70 kgf
Powered by 12 V , the holding electromagnet holds a mass of 70 kg under standard acceleration due to gravity (9.8 m/s 2 ). Current consumption during operation is approximately 850 mA. The rated power of the device is 10 W. The device has an installation hole with an M8 thread in the housing, and the set also includes an appropriate mounting screw. The electromagnet has dimensions: 59 x 27 x 34 mm. The length of the cables with the insulation removed at the ends is approximately 30 cm. If you use the device as an actuator controlled by Arduino , remember not to connect it directly to the microcontroller pins. For proper operation of the system, it is necessary to use a relay , opto-isolator or transistor amplifier .
Holding electromagnet 12V 10W 70kgf .
Electromagnet holding a load .
12V Holding Solenoid Specification
- Supply voltage: 12V
- Power: 10W
- Current consumption: approx. 850 mA
- Load capacity: 70 kgf (holds a mass of 70 kg for a gravitational acceleration of 9.8 m/s 2 )
- Cables with stripped insulation at the ends, approx. 30 cm long
- Mounting hole with M8 thread (screw included)
- Dimensions: 59 x 27 x 34 mm
- Weight: 500 g
Attention ! The manufacturer recommends maintaining good heat dissipation from the housing, because as the coil temperature increases, the holding force decreases. |
Useful links |
