Description
The module prevents the operation interference of the sensors through the insulation of the analog signal and providing an isolated power for sensors. Always during the measurement of the sensors prevent other sensors, for example, PH sensors affects the conductivity sensor. The solution is to isolate the power supply. After placing them in the same container and divide the same voltage, then their values will not be disrupted.
The module is powered with 5V voltage and is compatible with the 3-pin Gravity interface. It works in the Plug-and-Play technology with no soldering needed. It is compatible with most of the analog sensors.
|
Note:
|
Specification
- Working voltage: 5 V
- Response time: 4 seconds
- Analog error: <± 20 mV
- Interface type: PH2.0-3P
- Current consumption without load: 75 mA
- Dimensions: 42 x 32 mm
- The end is not insulated (Arduino side)
- Supply voltage: 5.0V± 0.1 V
- Analog output: 0 - 5.0 V
- The end is isolated (side of the sensor)
- Output voltage: 5.0± 0.2 V
- Analog input: 0 - 5.0 V
Useful links |
