• EOL

Grove - GPS UART module with antenna

Index: SEE-04406 EAN: 5904422373887

GPS module based on the system SIM28. It supports 66 channels, works with a voltage of 3.3 V and 5V, communicates through the UART interface (TX, RX). The kit includes a cable adapted to the Seeedstudio Base Shield v2.0 shield.

Grove - GPS UART module with antenna
€35.50
€28.86 tax excl.
Unavailable
Discontinued product
PayPal payment
Manufacturer: Seeedstudio
Compatibility: Arduino Raspberry Pi

Attention!

The product has been discontinued. Check other products in category.

Description

GPS module based on the system SIM28. It supports 66 channels, works with a voltage of 3.3 V and 5V, communicates through the UART interface (TX, RX). The kit includes a cable adapted to the Seeedstudio Base Shield v2.0 shield.

Specification

  • Supply voltage: 3.3 V or 5 V
  • SystemSIM28 
  • Data transfer rate:
    • Default: 9600 bit / s
    • Range : 9600 to 115200 bps
  • Protocol supportNMEA and U-Blox 6
  • Antenna is attached to the connector.FL
  • Equipped with 4-pin Grove, step 2 mm
  • Dimensions: 20 x 20 mm

 

The product is compatible with Arduino and Raspberry Pi

Connection

The sensor communicates with the microcontroller through UART interface. It has the following outputs:

Pin Description
GND The ground of the system.
VCC Supply voltage 3.3 V or 5 V.
RX The receiver of the serial interface UART.
TX The transmitter of the serial interface UART.

  

Voltage to 3.3 V
Voltage from 5.0 V
Interface UART
GPS - Accuracy -160 dBm
Package width 9 cm
Package height 1.1 cm
Package depth 14 cm
Package weight 0.017 kg

Be the first to ask a question about this product!

Customers who bought this product also bought:

Products from the same category: