• EOL

AD8232-EVALZ - evaluation board with a heart rate monitor

Index: MOD-09543 EAN: 1000865131

The evaluation board ad8232 equipped with module which controls the functioning of the heart. There are also components that are required for the preliminary analysis of measurement data. It can work in the mode with two or three electrodes.

AD8232-EVALZ - evaluation board with a heart rate monitor
€71.50
€58.13 tax excl.
Unavailable
Discontinued product
PayPal payment
Manufacturer: OEM

Attention!

The product has been discontinued. Check other products in category.

Description

The evaluation board ad8232 equipped with module which controls the functioning of the heart. There are also components that are required for the preliminary analysis of measurement data. It can work in the mode with two or three electrodes. Thanks to the available jumpers and switches, you can easily change the device's work mode: on/off, correction mode after connecting the electrodes, the mode of connection verification. The kit includes the board,the electrodes must be purchased separately.

Connection

Board supports up to three electrodes. Before connecting, make sure that the switches are set to the default values, as in the arrays below, depending on how many electrodes will be connected.

The array shows the settings for the 3 electrodes.

Switch/jumper Position Description
S1 FR_EN Fast Restore enabled
S2 DC DC leads off detection
S3 EN Operation enabled
INPUT BIAS_SECTION P3 Input bias set by RLD and +VS

The table shows the settings for the 2 electrodes

Switch/jumper Position Description
S2 AC AC leads off detection
INPUT BIAS_SECTION P4 Input bias set by RLD

Then, you need to connect power of 3.3 V and GND ground. Left and right arm (LA, RA) are connected to a source of the signal. The right leg (RL) to the reference source. The output signal is available at the OUT connector.

More information is available in the user's manualprepared by the manufacturer in English.

Key features

  • Supply voltage: 3.3 V
  • Ready-to-use heart rate monitor
  • The possibility to configure two or three electrodes
  • The acquisition of measurement data via A/D converter
  • Easy setup with the switches and sliders
  • A fully integrated front EKG panel
  • Output connectors for testing the correctness of connecting the electrodes
  • Low current consumption: 170 uA
  • The set does not contain electrodes

Package width 7 cm
Package height 1.1 cm
Package depth 12 cm

Be the first to ask a question about this product!

Customers who bought this product also bought:

Products from the same category: