- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: RFID wall-mounted reader MW-R7G - 13.56MHz - grey
Wall-mountedRFIDcardand proximity transponderreaderoperating at13.56 MHz. Compatible with MIFARE Classis, MIFARE Plus, MIFARE Ultralight C, MIFARE DESFire, ICODE SLI, iClass. Supported communication interfaces are RS232, RS485, 1-Wire, WIEGAND and CAN 2.0B. The reader is equipped with three GPIO pins. The device has a built-in RGB LED, buzzer and touch button. Casing version in grey. Mounting pins are included.
RFID reader MW-R7G - 13,56 MHz - grey.
Output description
The reader haseight leadsin the form of wires with removed insulation, placed on the back of the casing. Below is a description of individual connections.
| Description of reader outputs MW-R7G | |||
|---|---|---|---|
| The colour of the cable | Name | Function | |
| Red | VCC | Power supply | |
| Blue |
GND |
Mass |
|
| White | Anticolliosis | Bringing readers working closely together | |
| Brown | PinOUT |
Any destination |
|
| Green | PinTERFACE1 | Serial interface line: RS232_TX, RS485_B, CAN_H, WIEGAND0, 1WIRE | |
| Yellow | PinTERFACE2 | Serial interface line:RS232_RX, RS485_A, CAN_L, WIEGAND1 | |
| Grey | PinIN0 |
Entry for any purpose |
|
| Pink | PinIN1 |
Entry for any purpose |
|
RFID reader specification MW-R7
- Supply voltage: 8 V to 15 V
- Maximum supply current: 120 mA
- Average power consumption: 25 mA
- Rated RF frequency: 13.56 MHz
- Supported standards: MIFARE Classis, MIFARE Plus, MIFARE Ultralight C, MIFARE DESFire, ICODE SLI, iClass
- Supported communication interfaces: RS232, RS485, 1-Wire, WIEGAND and CAN 2.0B
- Operation with Netronix and MODBUS-RTU protocol in RS232/RS485 interface mode
- Number of GPIO pins: 3
- Card and transponder reading distance: up to 8 cm
- Leakage class: IP54
- Front button type: capacitive
- Built-in buzzer, antenna, RGB LED
- Dimensions: 83 x 44 x 14 mm
Useful links |
