- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: Parking reversing sensor set Blow PS-1 - 22 mm - black.
A set consisting of four ultrasonicparkingsensors. Efficientlyfacilitates reversing / parking by warning about obstacles both visually and acoustically. The obstacle detection range is from 0.1 m to 2 m.The diameter of the sensor hole is 22 mm.
|
Attention! In extreme cases, the sensor may temporarily fail to detect an obstacle, i.e.: on a plane at an angle of 45° or with objects of small diameter. This is due to physics principles (ultrasonic wave interference). |
Set of ultrasonic sensors - 22 mm.
The system is activated automatically when the reverse gear is thrown in together with the reversing lights. The control panel informs the driver about the exact position of the obstacle on theright or left on the attached display. A built-in piezoelectric transducer informs the driver about the distance from the obstacle with an acoustic signal at three frequencies, depending on the distance.
Specification of the Blow PS-1 reversing sensor kit
- Supply voltage: 10 V to 15 V
- Load capacity: up to 5 W
- Current consumption: up to 300 mA
- Operating temperature: -20°C to 60°C
- Operating humidity: 40% to 95%
- Alarm volume: 50 dB (10 cm)
- Alarm frequency: 2,3 kHz +/- 0,3 kHz
- Measurement area: horizontal 90°, vertical 70°
- Frequency: 40 kHz
- Number of sensors: 4
- Right or left hand obstruction information
- Measurement zones:
- 1 zone: 150 to 250 cm
- 2 zone: from 90 cm to 150 cm
- Zone 3: 60 cm to 90 cm
- 4 zone: from 0 cm to 60 cm
- The diameter of the hole: 19 mm
Included
- 4 ultrasonic hermetic sensors with 2 m wires
- Control panel
- Display with built-in buzzer
- Mounting accessories (including the appropriate drill bit)
