Ramps 1.4 RepRap driver for 3D printer

Index: MOD-02193 EAN: 5904422359133

Popular driver of 3D printer, adapted to work with Arduino Mega 2560 and stepper motors driver A4988. The system requires a power source with an output voltage of 12 V and minimum load current of at least 5 A.

Ramps 1.4 RepRap driver for 3D printer
€7.50
€6.10 tax excl.
Available
Shipping in 24 hours
PayPal payment
Manufacturer: OEM

Description

Driver to connectstepper motorsin the kit with additional elements needed to run a 3D printer. The system is compatible withArduino Mega 2560. It requires five modules withdriver A4988, to work. In addition to these elements, Ramps 1.4 enables connectingmechanical or optical limit sensors, devices to control the injection of plastic and an LCD display,SD memory card reader and Bluetooth module.

Ramps 1.4 RepRap - sterownik drukarki 3D

The Ramps 1.4 module is controlled through the Arduino Mega 2560 platform, which, thanks to its versatility, makes it easy to expand the system. Motors are controlled by popular, testes chips A4988, with maximum current up to 2 A per motor. Arduino Mega 2560 andthe A4988 driversare not included in the package. They can be purchased separately in our store.

 

A detailed description, diagrams and connection instructions can be found onthe Wiki-Ramps. The system is very popular among designers, has broad support, in the web you can find numerous examples using RAMPS 1.4.

 

Specification

  • Supply voltage: 12 V
  • Current consumption: minimum 5 A (depending on the configuration, details onthe wiki Ramps)
  • The system is compatible with Arduino Mega 2560
  • It requires five stepper motor drivers A4988
  • The system has the ability to connect limit sensors 
  • Connector AUX for connecting additional elements, for example, Bluetooth module (details onthe wiki Ramp)

 

Note

On the reverse side, included is 1N4004 diode. It is necessary to solder it in the spot marked D1, only in the case when the supply voltage does not exceed 12 V. After installing it, the Arduino Mega will be powered by a power source of module Ramps. If the voltage exceeds 12V or interference occurs in the form of voltage studs with large amplitude, the Arduino and the module Ramps will deteriorate. If there is a risk of such situation, the diode D1 should be left not soldered, and the Arduino shoul be powered from another source.

 

Details onwiki-Ramps.

 

 

 

Package width 12 cm
Package height 16 cm
Package depth 4.5 cm
Package weight 0.067 kg

Dawid

12/27/21

Question: If I have a 24v heater from a 3D printer, can I power the board with 24v?
Answer: The controller should be powered by the voltage as specified in the product specifications, which is 12V.

Product reviews

Ramps 1.4 RepRap driver for 3D printer

5/5

Average grade

3

Customers opinion
The following opinions are collected
and verified by
an external partner Trustmate
and come from the post-purchase process.

Reviews:

Pavel 03.04.2023 Confirmed purchase Translated review
functional, without reservations
Lesław W. 06.06.2022 Confirmed purchase Translated review
Quality OK. Used in a 3D printer
Marek 27.09.2022 Confirmed purchase

Customers who bought this product also bought:

Products from the same category: