Product description: Thermal imaging camera - FLiR Lepton Dev Kit V2
A kit containing the Flir Lepton V2 thermal imaging camera, and a board to facilitate its connection. The Lepton LWIR radiometric module has a resolution of 80 x 60 px and registers infrared radiation of wavelength range from 8 μm to 14 μm. An SPI interface is required to read the image. The I2C bus is used to configure the camera, although it is not absolutely required. The device is powered from 3 V to 5.5 V.
|Lepton Dev Kit V2 is compatible with Arduino and Raspberry Pi microcomputers.|
FLiR Lepton Dev Kit camera presentation.
Specifications FliR Lepton V2
- Wavelength range: 8 μm to 14 μm
- Measurement angle:
- For diagonal mode: 60°
- For HFOV mode: 50°
- Thermal sensitivity: up to 50 mK
- Resolution: 80 px (h) x 60 px (v)
- Single pixel size: 17 μm
- Frame rate: 9 Hz
- Frame rate: 9 Hz Image timeout: less than 1.2 seconds
- Average power consumption: approximately 150 mW
- Available interfaces:
- Supply voltage: from 3.0 V to 5.5 V
The module is sensitive to electrostatic discharge. Ensure proper grounding before installation.
Lepton V2 pinout and description
The FLiR Lepton Dev Kit V2 thermal imaging camera, has 20 pins to connect the wires. Their diagram and description is illustrated by the following graphics.
Schematic and pinout of the module.
Comparison of the FLiR Lepton and FliR Lepton V2 Models
|Model:||EFLiR Lepton Dev Kit||EFLiR Lepton Dev Kit V2|
|Resolution:||80 x 60 px||80 x 60 px|
8 μm to 14 μm
8 μm to 14 μm
|Measuring angle for HFOV mode:||51°C||50°C|
|Thermal sensitivity||up to 50 mK||up to 50 mK|
|Frame rate||less than 9 Hz||less than 9 Hz|
|Image waiting time:||
less than 0.5 s
less than 1.2 s
|Metering angle for HFOV mode:||51°C||50°C|
|Average power consumption||approx. 150 mW||approx. 150 mW|
|Supply voltage:||3.0 V to 5.0 V||3.0 V to 5.5 V|
Contents of the kit
- FLiR Lepton V2 camera module
- Printed circuit board with leads