- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: WiFi controller with 0,96" OLED display - tinyESP
Factory programmedWiFi controllerfrom tinyESP with open source software EasyESP. The model is equipped with OLED 0,96" display. It has built-inESP266chip which makes WiFi communication possible. The device should be powered by microUSB cable (5 V) or Li-Pol battery.
Basic features
- OLED display informing about read parameters
- One relay with NO, C, NC contacts
- Universal logic or pulse input
- I2C bus and UART serial port
- 1-wire bus for temperature sensors
- Buzzer, which can be used to send audible notification
- IRDA - infrared controlled IRLED transmitting diode
|
The manufacturer provides a user manual inPolishandEnglishand a detaileddescription ofthe WiFi controller. |
WiFi controller with a 0.96" OLED display - tinyESP.
The controller can be powered via the microUSB port or Li-Pol battery.Suggested use
- Measurement of ambient parameters: temperature, humidity, smog level, CO2, lighting
- Voltage measurements in the range from 0 V to 5 V
- 0-1 logical state control
- Cyclic sending of measurements to own server (eg Domoticz, OpenHAB) or to the cloud (eg mqtt.ats.pl)
- Device control using relay or IRLED transmitting diode
- Simple automation - switching on the relay after exceeding the setting from the sensor
- Notification via e-mail messages
- Monitoring of current data using built-in OLED display
- Simple distance measurement
- Support for RFID readers
Technical specification
- Supply voltage 5 V
- Relay: max. 3 A / 120 V AC
- Maximum power consumption: 5 W
- Radio interface: WiFi 2.4 GHz 802.11bgn
- Dimensions: 72 x 40 x 3 mm (without DIN holder)
- Weight: 42 g
