Product description: Pulling electromagnet - 12V 21W 150g
The solenoid allows to perform a linear - pulling motion with a voltage signal of 12 V. The range of the bolt is approximately 10 mm. The device has a mounting hole with a diameter of 2.5 mm. Powering wires with insulation removed at the ends, have a length of approx. 20 cm
|
Attention! The Solenoid consumes a relatively large current so connecting it directly to the pins of the microcontroller will lead to irreversible damage to the system. |
Specification of pulling electromagnet
- Supply voltage: 12 V
- Current consumption: approx. 1.8 A
- Power: 21 W
- Wires: 20 cm, without connector
- The range of bolt: 10 mm
- Load: 150 g
- Mounting holes with the diameter of 2,5 mm: spacing of 19 mm
- Body dimensions: 27 x 25 x 22 mm
- Weight: 66 g
