Description
Holding electromagnet is powered with voltage of 12 V . It keeps the weight of 280 kg by standard earth acceleration of 9.8 m/s2. The dimensions of the electromagnet are 250 x 48 x 26 mm. Included is a set of mounting screws.
The device can be used as an actuator controlled by any microcontroller, e.g. an Arduino. Please note that an electromagnet consumes too much power to connect it directly to the pins of the microcontroller. For this purpose, you can use relays, optical isolator or transistor amplifier.
|
Attention! The manufacturer recommends maintaining a good heat dissipation from the housing, because with the temperature rise of the coil, the force that holds, decreases. |
Specification
- Supply voltage: 12 V
- Current consumption: approx. 350 mA
- Load: 280 kgf (keep the weight of v280 kg for the gravitational acceleration of 9.8 m/S2)
- The wires with insulation removed at the ends with the length of about. 12 cm
- The set has the installation screws
- Temperature limit: 130 °C
- Electromagnet dimensions:250 x 48 x 26 mm
- The dimensions of the metal board:175 x 37 x 11mm
Included
- Eelctromagnet
- Metal board
- Set of installation screws
- Hex key
