Description
Holding electromagnet is powered with voltage of 12 V with power of 4.2 W. It keeps the weight of 180 kg by standard earth acceleration of 9.8 m/s2. The dimensions of the electromagnet are 170 x 40 x 21 mm. Included is a set of mounting screws.
The device can be used as an actuator controlled by any microcontroller, e.g.an Arduino. Please note that an electromagnet consumes too much power to connect it directly to the pins of the microcontroller. For this purpose, you can userelays,optical isolatorortransistor amplifier.
|
Attention! The manufacturer recommends maintaining a good heat dissipation from the housing, because with the temperature rise of the coil, the force that holds, decreases. |
Specification
- Supply voltage: 12 V
- Power: 4.2 W
- Current consumption: approx. 350 mA
- Load capacity: 180 kgf (holds weight of 180 kg for the earth acceleration 9.8 m/S2)
- The wires with removed insulation at the ends with a length of about 12 cm.
- Included is a set of mounting screws
- Limit temperature: 130 °C
- Electromagnet's dimensions: 170 x 40 x 21 mm
- The dimensions of the metal board: 130 x 32 x 12 mm
Included
- Electromagnet
- Tile metal board
- Set of mounting screws
- Allen key
