- EOL
Attention! The product has been discontinued. Check other products in category. |
Product description: RFID wall reader UW-R4G - 13.56 MHz
A wall-mounted RFID transponder and proximity card reader.Works on13.56 MHzfrequency. Supports MIFARE standards: Classis, Plus, Ultralight C, DESFire iCLASS (CSN only), ICODE SLI. UW-R4G has RS485 interface with Netronix and MODBUS-RTU transmission protocol. The reader is equipped with a buzzer, relay, two signaling diodes, antenna and RTC clock.
Wall RFID reader UW-R4G - 13,56MHz.
The UW-R4G has acard memory with a built-in lock controllerand event memory with the possibility of masking power sources. Built-in pin allows you to synchronize the readers working closely together. The reader is equipped with a built-in tamper with a spring and a button to return to factory settings.
Supported functionalities
Supported functionalities depending on card type (transponder) | |||
---|---|---|---|
MIFARE card type | Reading the ID number |
Full write and readout memory blocks |
Handling by internal Bolt driver |
S50 | Yes | Yes | Yes |
S70 |
Yes |
Yes |
Yes |
Plus S, Plus X | Yes | Yes. (SL1, SL3) | Yes |
Ultralight | Yes | Yes | Yes |
Ultralight C | Yes | Yes |
Yes |
DesFire | Yes | Yes | Yes |
iClass | Yes. (CSN) |
No |
Yes |
I-CODE |
Yes |
Yes |
Yes |
Specification of the UW-R4G wall reader
- Supply voltage: 8 V to 16 V
- Maximum supply current: 200 mA
- Maximum current of open collector type outputs: 1 A
- Maximum total output current: 2 A
- Frequency of module operation: 13.56 MHz
- Reading distance of transponders: up to 8 cm
- Supported communication interfaces: RS485, MODBUS-RTU protocol
- Addressing on RS-485 bus
- Two-state input and output configuration function
- Function to control two-state outputs
- Reading function of two-state inputs
- Built-in configurable buzzer, relay and two LEDs
- Built-in RTC clock
- Dimensions: 82 x 82 x 22 mm
Set contents
-
RFID wall reader UW-R4G
- Screw connections
- Mounting accessories (dowels and screws)
Useful links |