- EOL
|
Attention! The sale of the product has been completed. Check otherdevices in this category. |
Specification
- Supply voltage: 2.2 V to 3.6 V
- Current consumption: 0.5 mA
- Measuring range:
- +- 3 G (800 mV/G)
- +- 11 G (206 mV/G)
- Dimensions: 12 x 23 x 2.3 mm
- Weight: 1 g
- No voltage regulator
- Set contains: straight goldpins, angle goldpins and jumper
Description
The sensor is used to measure accelerations in three axes. It is a module with a 3D accelerometer MMA7361L fromFreescale. The output data is sent to the central unit in an analogue form. Outputs are popular goldpin connectors, which allow to connect the sensor by wires or directly to the contactplate.
Accelerometers with built-in voltage regulator MMA7361L operatinginthe range of 1.5G or 6G and MMA7341L - 3G or 11G are also available in our shop.
|
Attention! Before connecting, please readdocumentationmodule. |
Queries
A VIN is connected to the 2.2 V to 16 V power supply.
Pins X, Y and Z arethe analogue outputs of the respective accelerometer axis. The outputs are centred at half the voltage of the 3V3 pin. Positive acceleration increases and negative acceleration decreases the voltage.
The g-Select sensitivity selection pinisinternally pulled to ground, which sets the default range at:
- +/-1.5G (800mv/G) for MMA7361L
- +/-3G (440 mV/G) for MMA7341L.
The high state changes the range to:
- +/-6G (206 mV/G) for MMA7361L.
- +/-11g (118 mV/G) for MMA7341L.
Pin0g-Detect isin high state when all three axes detect 0 G.
The PinSelfTest isinternally pulled to ground. Its connection is not required for proper module operation. Seedocumentationfor details.
|
Attention! The SelfTest and g-Select pins do not work with 5V! |
Dimensions
The outline of the system shall be contained in a rectangle of dimensions: 13 x 10,5 mm The overall thickness shall not exceed 2,5 mm.
Useful lines |
