Description
The solenoid allows to perform a linear - pulling motion with a voltage signal of 12 V. The range of the bolt is approximately 10 mm. The device has a mounting hole with a diameter of 2,5 mm, suitable for screws with M3 thread. The powering wires with insulation removed at the ends, have a length of approx. 20 cm.
|
Attention! The Solenoid consumes a relatively large current so connecting it directly to the pins of the microcontroller will lead to irreversible damage to the system. |
Specification
- Supply voltage: 12 V
- Current consumption: approx. 300 mA
- Wires: 20 cm, without connector
- The range of bolt: 10 mm
- Load: 0.4 kg
- Mounting hole with the diameter of 2.5 mm with M3 thread
