Sound and acoustics - Strona 2
MAX9814 - electret microphone with amplifier - Adafruit 1713
The module is equipped with electret microphone in the range from 20 Hz to 20 kHz and amplifier MAX9814 with auto gain control. The voltage of the work of 2.7 V to 5.5 V. The...Speaker YD40 0.25W 50Ohm - 40x16mm
Speaker power 0.25 W, impedance of 50 Ohms, and dimensions of 40 x 16 mm.HeadAmp 2016 set + Noise Reduction
Headphone amplifier is an official product of YouTube channel Noise Reducer. The kit contains a main board with soldered SMD components and a set of THT components for...Battery charge level and sound level indicator - KA2284
The module is based on the KA2284 system. It is used to measure the input signal with the 5 LEDs, which are gradually included depending on the value of the measured voltage....Grove - Buzzer - module with active buzzer
Active buzzer module from Grove. It e mits a uniform tone after taking a high position. When using PWM, it can generate different sounds and effects. The power voltage from 4...MP34DT01-M - PDM MEMS microphone - Adafruit 3492
MEMS microphone based on PDM (Pulse Density Modulation) signal. It has a built-in MP34DT01-M module and communication is via PDM interface. The signal to noise ratio SNR is...DFRobot Gravity - sound sensor - analog
Sound sensor module with analog output. Works with a supply voltage from 3.3 V to 5 V. It enables the determination of the volume or identifying characteristic sounds from the...Grove - a speaker with a digital interface
Speaker module Grove is a device controlled by the PWM signal. It c an work as a simple buzzer or audio player. The volume is adjustable with the built in potentiometer. The...DFRobot Gravity - a speaker with a digital interface
The module is based on the single-wire 8002 amplifier with digital interface. It can work as a simple buzzer or play music. The volume is adjustable with built in...Mini Oval Speaker 1W 8Ohm - 30x20x5mm - Adafruit 4227
Small speaker with 1W power and 8 ohm resistance. It is equipped with a 2-pin JST connector with a 1.25 mm pitch so you can plug it directly into consoles such as PyGamer...Amplifier audio stereo 2x3W 5V PAM8403
A module with a universal two channel amplifier, powered by voltage of 5 V. It allows you to connect the speakers from 4 Ohms to 8 Ohms and 3 watts each. The module has...Buzzer with generator 32mm 12V in a case
Module with buzzer with a generator in a case with put out wires and mounting handles.Speaker MG6-15 0.1W 32Ohm - 15x6x3mm
Speaker with power of 0.1 V, the resistance of 32 Ohms and a size of 15 x 6 x 3 mm.Sound detector - microphone - SparkFun SEN-12642
Audio detector powered with the voltage ranging from 3.5 to 5.5 V. The module is easy to use, it has three outputs: an analog - to measure the intensity of the signal, digital...SPW2430 - module with MEMS microphone - Adafruit 2716
Module with silicon microphone, MEMS type, which does not require amplifier. It detects sound with frequency from 100 Hz to 10 kHz and converts it into an analog output signal...Sound sensor - microphone - Iduino SE019
Module with microphone the detects sound. Voltage supply range from 3.3 V to 5 V. It has two outputs: an analog - to measure the intensity and a digital - changing state when...Whadda WPSE309 - sound sensor - microphone
Sound detector powered by a voltage from 3.3 to 5 V . The module is easy to use, it has two outputs: analogue - enabling measurement of signal intensity and digital -...Fermion - MEMS analog microphone module - DFRobot SEN0487
MEMS microphone module manufactured by DFRobot. The device has an analogue signal on its output and is powered with 3.3 V / 5 V , so that the module can be used with all...DFRobot Gravity - MP3 player - JQ8400-FL UART
Module that allows you to play music files directly from the 8 MB device memory . It supports MP3 and WAV formats. It communicates with the microcontroller via the UART...Audio FX Mini Sound Board - WAV/OGG player 16MB - Adafruit 2341
Standalone module which supports playback of wav or oog files stored in memory. The device is powered with voltage from 3 V to 5.5 V, has stereo output which can be programmed...WTV020 - MP3 player / decoder with microSD slot
A module that allows you to play music files directly from a microSD card via the built-in connector. Supports cards up to 1 GB. Supply voltage is from 2.6 V to 3.6 V.MP3 Player VS1053 Shield - Shield for Arduino - SparkFun DEV-12660
A module that allows you to play music files directly from micro SD card via the built-in slot. Output is a 3.5 mm Jack to connect speakers or headphones.Module with loudspeaker for testing A/C and C/A converters - Waveshare 3972
Module with amplifier LM386M, speaker and two high precision potentiometers, that allows you to check external converters analog-to-digital and digital-to-analog.Sound Card uGo Virtual 5.1 USB - UKD-1085
The sound card from uGo is equipped with a headphone output and a microphone input. The adapter has a USB type A connector that allows you to connect it to any device with...See also
- Computer accessories
- Automobile accessories
- Cooling
- Diodes
- Mounting components
- Passive elements
- Wearables (e-textiles, smart clothes)
- Cameras and recorders
- Memory cards & disks
- Communication
- Converters
- Electronics courses
- Microcontrollers
- Animal repellers
- LED lighting
- Programmers
- Relays
- Voltage regulators
- Artificial intelligence
- Motor drivers and servos
- Integrated circuits
- Displays and screens
- Tablets and smartphones
- Consoles