A module that allows you to build a fully functional radio with RDS function. It is controlled by the I2C bus. It is powered with the voltage from 2.5 V to 5.5 V. It has a high sensitivity thanks to the integrated low-noise amplifier. It works, i.a. with Arduino, AVR, Raspberry Pi.
- Supply voltage: 2.5 V to 5.5 V
- Supply current: 15 mA
- Modulation: FM
- Frequency range: 70 MHz to 108 MHz
- Built-in quartz resonator: 32.768 kHz
- Communication interface: I2C
- Pins' pitch: 2 mm
- Sizes: 11.2 x 11.2 mm
Details in the documentation.
The system has the pins for surface SMD soldering. The pitch is 2 mm.
|1||SDA||The data line of the I2C bus.|
|2||SCL||Clock line of the I2C bus.|
|3||BUSMODE||You need to connect it to ground.|
|4||Write/Read||You can leave it unconnected.|
|5||VCC||The supply voltage of 5 V.|
|6||GND||The ground of the system.|
|7||R-out||Output - right channel.|
|8||L-out||Output - left channel.|
|9||MPX0||You can leave it unconnected.|
|10||ANT||The pin for the antenna connection.|