Product description: Motoron M3S256 - three-channel motor driver - 48 V / 2 A - shield for Arduino - kit for self-assembly - Pololu 5031
Three -channel motor driver for Motoron M3S256 from Pololu. The input voltage is in the range from 4.5 V to 48 V , the continuous current consumption is up to 2 A , and the instantaneous (for 1 second) up to 6.4 A. Motoron M3S256 is a shield designed to work with Arduino or its derivative board, such as A-Star 32U4 Prime . The subject of the sale is a set with connectors intended for self-assembly.
The product is compatible with Arduino!
Before starting work, also check the user's guide prepared by the manufacturer.
Motoron M3S256 - three-channel motor driver - 48 V / 2 A - shield for Arduino - kit for self-assembly - Pololu 5031.
How to connect the controller with the engine? - Motoron M3S256 driver connection diagram.
Special features of the Motoron M3S256 controller
- Equipped with a Motoron M3S256 driver system, which allows you to control up to three motors at a time
- Performs optional cyclic redundancy checking (CRC)
- It has a command timeout feature that stops the motors from running if the Arduino stops working
- It has a built-in thermal cut-off circuit
- It contains filter capacitors located on both power lines
- Provides protection against motor reverse current
The subject of the sale is a Motoron M3S256 motor driver in a version with connectors for self-assembly . In our offer you will also find a version with connectors and a version without connectors .
Motoron M3S256 driver specification
- Number of channels: 3
- Input voltage: 4.5 V to 48 V
- Logic supply voltage: 2.8 V to 5.5 V
- Continuous output current: 2 A per channel
- Maximum instantaneous current per channel: 6.4 A peak for 1 second
- Communication interface: I2C
- Maximum I2C frequency: up to 400 kHz
- Configurable traffic parameters:
- Maximum acceleration / deceleration forward / reverse
- Initial speed forward / reverse
- Forward / Reverse direction change delay
- Maximum PWM frequency: configurable - eight options available from 1kHz to 80kHz
- Configurable automatic error response
- Measurement of engine supply voltage (VIN)
- Two LEDs indicating the operating status of the controller
Kit contents
- Motoron M3S256 board - three-channel motor driver - 48 V / 2 A - shield for Arduino - 1 piece
- 1x25 goldpin strip - 2.54 mm raster - 1 piece
- Female rail with long pins 1x10 - 2.54 mm raster - 1 piece
- Female strip with long pins 1x8 - 2.54 mm pitch - 1 piece
- 2-pin screw connector - 3.5 mm - 4 pieces
- 2-pin screw connector - 5 mm - 4 pieces
The location of the pins of the Motoron M3S256 driver.
