





Popular module with microcontroller AVR Atmega32U4. It has 32 KB of Flash memory, 2.5 KB RAM, 20 digital inputs/outputs, 7 of which can be used as PWM channels and 12 as analog inputs and popular communication interfaces, including USB. This version does not have soldered connectors.
The Arduino Leonardo is one of the most popular versions of the series. The board contains an ATmega32u4 microcontroller equipped with the 20 digital inputs/outputs, 7 of which can be used as PWM outputs (e.g. for motor control) and 12 as analog inputs. The system works with the signal ticking with the frequency of 16 MHz, has 32 kB of Flash memory and 2.5 KB of SRAM.
The subject of the sale is the original product for Arduino, Botland is the official distributor of this company.
This version does not have soldered connectors, the user decides which connectors and in which places solder them. In our offer, you will also find Arduino Leonardo with connectors. |
Below are a few features that distinguish modules Arduino compared to other programmable tiles.
Name | Description |
---|---|
Installed bootloader |
Thanks to bootloader, for programming the device sufficient are micro usb cable and the software from the manufacturer's website. |
Arduino Shield |
The distribution of connectors allows the installation of special plates, so-called Arduino Shield, after soldering connectors. |
Digital leads |
20 digital inputs/outputs allow, i.a. the control of LEDs, relays and the reading the buttons' states. |
Current efficiency |
The maximum current efficiency for a single output is 40 mA. |
PWM outputs |
7 PWM outputs allow the motor control and the brightness control of the LEDs. |
Analog inputs |
12 inputs of built-in analog to digital converter with 10 bits of resolution, support, i.a. sensors with analog output. |
Serial communication |
The device supports popular communication interfaces, i.a.: UART, I2C and SPI, and USB. |
Special functions | Some of the pins have special functions which brief description is available in our guide. |
Built-in memory |
The Atmega32u4 chip is clocked with the signal with clock frequency of 16 MHz and has 32 KB of Flash memory, 1 KB EEPROM and 2.5 KB of SRAM. |
Power DC connector |
To power the Arduino, you can use any power source with a voltage from 7 V to 12 V with DC connector 5.5 x 2.1 mm. |
Power USB port |
The tile can be powered from a computer via microUSB cable, bearing in mind that the maximum current efficiency for the USB port is 500 mA. Arduino has a system that protects the socket from short-circuit and from the flow of too high current. |
ICSP Connector |
The module has leads ICSP for connecting an external AVR programmer. |
Pin IOREF |
The IOREF pin provides direct access to the voltage with which leads I/O work. |
Built-in led |
The connected LED on pin 13, allows debugging simple programs. |
Output 3.3 V |
Built-in voltage regulator provides power to external devices with the voltage of 3.3 V with current consumption up to 50 mA. |
First run To help you get started with the module, we have prepared a tutorial that applies to the installation and first run of the Arduino environment. |
Useful links |
Voltage to | 7.0 V |
Voltage from | 12.0 V |
Voltage output from | 5.0 V |
Output voltage to | 5.0 V |
Nominal output voltage | 5.0 V |
UC - Microcontroller | Atmega32U4 |
UC - Core | 8-bit AVR |
UC - EEPROM | 1 kB |
UC - Flash | 32 kB |
UC - RAM | 2,5 kB |
UC - core | 1. Single Core |
UC - Digital pins | 20 |
UC - analog in | 12 |
UC - freq | 16 MHz |
UC - PWM | 7 |
UC - USB | microUSB |
UC - I2C | yes |
UC - UART | yes |
UC - SPI interface | yes |
Posting the payment for the order on our account on a business day up to 10 AM means sending the goods on the same day!
The time of payment depends on the ELIXIR's hours session of the sender's bank and the recipient of the transfer. It may take up to 2-4 working days.
Only for prepaid orders shipped to Poland.
Austria, Belgium, Croatia, The Czech Republic, Denmark, Germany, Netherlands, Slovakia
Bulgaria, Estonia, France, Hungary, Italy, Latvia, Lithuania, Luxembourg, Portugal, Romania, Slovenia
Finland, Greece, Ireland, Sweden, Cyprus, Malta, Spain
No customer reviews for the moment.
Sharp GP2D120XJ00F - analog distance sensor 4-30cm
Analog distance sensor (rangefinder) Sharp GP2Y0A41SK0F to detect objects in the range from 4 to 30 cm.TB6612FNG - two-channel motor controller 13.5V / 1A - Pololu 713
Polol module with a two-channel direct current motor controller. It is powered from 4.5 V to 13.5 V. Continuous current per channel is 1 A, with both channels connected the...Pololu MMA7341LC 3-Axis Analog Accelerometer with reg. 3/9g
3-axis Acceleration sensor operating in the 3G or 11G range. It has an integrated voltage regulator for power supply: 2.2 V - 16 V. The system communicates by means of an...High-Power 18v15 - single-channel 30V/15A motor controller - Pololu 755
Based on MOSFET transistors, the powerful H-bridge allows you to control the motor rotation in both directions. Motor power supply: from 5.5 V to 30 V. Maximum current: 15 A.MinIMU-9 v2 - accelerometer, gyroscope and magnetometer IMU I2C - Polol module
Sensor for measuring acceleration, magnetic field and angular velocity. It is a combination of a 3-axis accelerometer, magnetometer and gyroscope. It communicates via the I2C...MicroUSB B - A cable Esperanza EB-143 - B 1,0m
USB cable (type A) - microUSB cable (type B) used to connect your computer to devices equipped with microUSB-B sockets. Length: 1 m.Customers who bought this product also bought:
CNY70 reflective optocoupler sensor
Reflective optocoupler used, for example, to distinguish the edges or for line detection. Case dimensions - 7 x 7 x 6 mm,through hole installation.L293D - two-channel 36V / 0,6A motor driver - 5pcs
Two-channel motor controller. Supply voltage up to 36 V . Average current per channel 600 mA (momentary up to 1.2 A). Enclosure: DIP 16 (scrolling). Set contains 5 pieces of...DC motor - Micromotors HL149 with 21:1 transmission
HL149 DC motor with 21:1 geared motor. 0.075 Nm (0.76 kgcm) torque. Speed 160 rpm. Nominal supply voltage 6 V.Active buzzer with generator 5V 12mm - THT
Buzzer with continuous tone generator with a diameter of 12 mm. Power voltage of 5 V.Limit switch mini - WK601 - 5 pcs
Limit switch with lever. Maximum operating parameters: voltage of 250 V and current of 5 A. 5 pcs.Connecting cables male-male - 65pcs.
A set of 65 connecting wires to the breadboards of different lengths and in different colors.Connecting cables female-male 20cm - 40pcs
Set includes 40 PCs of multi-colored connecting cables with a length of 20 cm, on one side ended with a female connector, on the other, with a male connector.Mounting potentiometer 47kΩ - 5pcs
Horizontal mounting potentiometer RM-065 in the through hole case with a resistance of 47 kΩ. Price is for 5 pieces.AVR microcontroller - ATmega16A-PU - DIP
Popular microcontroller AVR from Atmel in a DIP case.Products from the same category
Arduino Leonardo - module A000057
Popular module with AVR microcontroller Atmega32U4. Has 32 KB Flash memory, 2.5 KB RAM, 20 digital inputs/outputs, of which 7 can be used as PWM channels and 12 as analog...Arduino Uno Rev3 - module A000066
The original module from the Arduino Uno with the AVR microcontroller ATmega328 in an interchangeable housing. It has 32 KB Flash memory, 2 KB RAM, 14 digital I/o of which 6...Arduino Pro Mini 328 module - 5V/16MHz - SparkFun DEV-11113
The module based on the Arduino Uno is characterized by small size and low profile. There is an Atmega328 microcontroller with 32 KB Flash memory, 2 KB RAM, 14 digital I/o, 6...Arduino Mega 2560 Rev3 - module A000067
Popular module with microcontroller AVR ATmega2560 . It has 256 KB Flash memory, 8 KB RAM, 54 digital inputs/outputs, of which 15 can be used as PWM channels, 16 analog...Arduino Micro - module A000053
Module based on the Arduino Leonardo with Atmega32U4 AVR microcontroller, is characterized by small size. Has 32 KB Flash memory, 2.5 KB RAM, 20 digital inputs/outputs, of...Arduino StarterKit K000007 - the official starter set with Arduino Uno A000066
Starter set introducting to the world of Arduino programming. Allows the construction of more than a dozen projects using Arduino and i. a.: temperature sensor, photoresistor,...Arduino Pro Mini 328 module - 3.3 V/8 MHz - SparkFun DEV-11114
The module based on the Arduino Uno, is characterized by small size and low profile. It has an Atmega328 microcontroller with 32 KB Flash memory, 2 KB RAM, 14 digital I/o, 6 of...Arduino Due ARM Cortex - module A000062
The popular run set based on the Atmel AT91SAM3X8E. Thanks to the Arduino Due, the user can create layouts using a system with a 32-bit core ARM Cortex, based on libraries for...Trinket - Mini Microcontroller module - 5V - Adafruit 1501
Miniature module with an AVR Attiny85 microcontroller and is equipped with 8 KB of Flash memory, 5 digital pins, analog input and 2 PWM channels. On board is microUSB...Makey Makey - version Classic - by JoyLabz - SparkFun KIT-14478
This kit consists of USB board and cables, allows you to create keyboard of any items, such as chagning the stairs into piano or making the gamepad from the fruits. The device...Cytron Maker Uno - compatible with Arduino
The Cytron module, compatible with Arduino Uno R3. It has 14 digital input/outputs, 6 PWM channels, 6 analog inputs, as well as popular communication interfaces. In addition,...