Description
Module from the Grove is equipped with a button with a yellow led. It is powered with the voltage from 3.3 V to 5 V. It has the Grove connector that allows for the direct connection of the board to the Raspberry Pi and Arduino. The switch, by default, is set to high status and the LED to the low status.
Attention! This product is only available in our market in Poland and cannot be sold to other countries. |
Connection
The module is equipped with Grove interface that facilitates its connection to the Arduino along with the Base Shield v2.0 or Raspberry using the Hat from the GrovePi+.
Pin | Description |
---|---|
1)GND | The ground of the system. |
2)VCC | Supply voltage from 3.3 V to 5 V |
3)SIG2 | The signal output of the button's status. High, by default. |
4)SIG1 | The signal input of the LED. Low by default. |
Grove is a series of modules and sensors that are compatible with Base Shields working with Arduino and STM32 Nucleo. |
Specification
- Supply voltage: from 3.3 V to 5 V
- Supply current of LED: 50 mA
- Type: normally closed (NC)
- The resistance of the pressed button: < 100 mΩ
- The resistance of the released button: > 100 MΩ
- Dimensions: 40 x 20 x 16 mm
- Weight 30 g
Useful links |