- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description
The module allows you to control four DC motors and two stepper motors - bi or unipolar. It also has two connectors for connecting servos. Applied dualH bridges TB6612allow you to control DC motors with a voltage from 4.5 V to 13.5 V, with current consumption up to 1.2 A (temporarily up to 3 A) per channel. Tile communicates via I2C interface so its maintenance requires only two leads of the Arduino.
Key module features:
- Two connectors for connecting the modelling servos - supply voltage is 5 V.
- The posibility to connect fourDC motors, through the use of two dual channel driversTB6612:
- supply voltage: 4.5 V to 13.5 V,
- DC consumption: up to 1.2 A per channel,
- temporary consumption of current: up to 3 A per channel.
- Can connect twostepper motors- unipolar, bipolar with single or dual coil.
- The posibility of connection simultaneously two DC motors, one stepper motor and two servos.
- Solderedscrew connections facilitating the connection of motors and supply - compatible with the wires 18 - 26 AWG.
- Protection against the reverse connection of the supply voltage.
- Jumper that allows the separation of the power of the logical part from the engines.
- Works with logic voltages of 5 V and 3.3 V - selected with jumper.
- The product is tested with:Arduino Uno,Arduino Leonardo,Arduino Mega,Arduino Mega ADK,Arduino Due, Diecimila and Duemilanove.
- Uses only two signal pins of the Arduino: SCL and SDA
- The public, freelibrary Arduino.
- Communication via the I2C bus with 7-bit address selected with jumper from the range of 0x60 - 0x80.
- Dimensions: 70 x 55 x 10 mm.
Included:
- Board with motor controller
- Strip goldpinfor self-soldering, in case of further extension to other Shieldy, we offer you to buy extended connectors
|
The product is compatible with Arduino The manufacturer providesthe Arduino library in GitHubalong witha user manual. |
Examples of projects
Useful links |
