- EOL
|
Attention! The sale of the product has been completed. Check others in thiscategory. |
Description
A converter that allows communication between USB and UART serial interfaces for pcDuino debugging.It allows for data exchange between the computer and systems using microcontrollers. Module based on FT232RL chip. In the operating system visible as a virtual COM port. It has a miniUSB connector. The chip works with Windows 7 and Windows 8/8.1, without the need to install drivers.
The module can be used for data exchange between the computer and microcontroller system or for programming boards with serial interface, e.g.ArduinoorpcDuino. In the operating system visible as a virtual COM port. It has a miniUSB connector and 3 LEDs informing about supplying, sending and receiving data.
The device works with voltage of 5 V. The board has connectors with a raster of 2.54 mm to allow connection by wires.
Connection
The description of the outputs is given in the table.
| Pin | Description |
|---|---|
| DTR | Data readiness check signal / handshake signal. |
| RX | Pin of the UART receiver. |
| TX | UART transmitter pin. |
| 3V3 | Power supply 3.3 V. |
| CTS | Transmission control signal |
| GND | The weight of the system. |
Included
- USB-UART converter FT232RL: dimensions 33 x 18 mm
- 3 x male/female cable: 20cm
- MiniUSB - USB cable: 20cm
Useful links |
