Product description: SparkFun Indoor Air Quality Sensor - ENS160 air quality sensor - Qwiic - SparkFun SEN-20844
SparkFun Indoor Air Quality Sensor is a SparkFun module based on the ENS160 system that allows you to monitor the purity of indoor air . Enables the detection of volatile organic compounds (VOCs), including ethanol, toluene, hydrogen. It has been equipped with two Qwiic connectors that allow quick connection to boards such as Arduino without the need to solder the leads. The module has excellent measurement stability over the entire T and RH operating range. It communicates using the I2C interface.
Arduino compatible product!
The manufacturer has prepared a detailed user's guide that makes it much easier to start working with the module.
SparkFun Indoor Air Quality Sensor - ENS160 air quality sensor - Qwiic - SparkFun SEN-20844.
The sensor has leads in the form of solder pads and two Qwiic connectors.Description of the module pins
- GND - system ground
- 3V3 - 3.3V power pin
- SDA - data line of the I2C bus
- SCL - clock line of the I2C bus
- ADR - SPI address jumper
- CS - Chip Select - SPI / I2C selection
- INT - internal interrupt pin
Kit contents
- SparkFun Indoor Air Quality Sensor - ENS160 air quality sensor - Qwiic
Module technical specification
- Built-in chip: ENS160
- eCO2 measurement range: 400 ppm to 65,000 ppm
- TVOC measurement range: 0 ppb to 65000 ppb
- Acceptable working environment:
- temperature range: -40°C to +85°C
- humidity range: from 5% to 95%
- excellent output stability over the entire T and RH operating range
- effective ozone compensation
- Complies with IAQ standards for AQI, eCO2 and TVOC
- Communication interface: I2C bus
- Interface address: 0x53 (default) or 0x52 (configurable)
- Pins: Qwiic connectors / solder pads
- Operating voltage range
- VDD: 1.71V to 1.98V
- VDDIO: 1.71V to 3.6V
- Qwiic: 3.3V
ENS160 air quality sensor from SparkFun.
