Product description: Digital Temperature Sensor - STTS22H - Qwiic - SparkFun SEN-21262
Digital temperature sensor equipped with the STTS22H system by STMicroelectronics, which is characterized by high measurement accuracy and low power consumption. The module is factory calibrated and the reading is accurate to ±0.5°C from -10°C to 60°C. The full range of temperature measurement is from -40°C to 125°C . The sensor for communication uses the I2C interface with the default address 0x3C and the possibility of changing it to the address 0x3E, 0x38 or 0x3F using a jumper. The module has three operating modes that are selectable by the user - Freerun, one-shot and Low-ODR.
The manufacturer has prepared a detailed user guide - check it out!
Temperature sensor - STTS22H - Qwiic - SparkFun SEN-21262.
Digital temperature sensor from SparkFun with high measurement accuracy.
Pin description
The module has been equipped with leads in the form of soldering pads to which goldpin connectors can be soldered, and two Qwiic connectors that do not require additional soldering. Connect the pins according to the diagram below:
- GND - system ground
- 3V3 - supply voltage 3.3 V
- SDA - data line of the I2C bus
- SCL - clock line of the I2C bus
- INT - internal interrupt pin
Module technical specification
- Type: digital temperature sensor
- Chip: STTS22H
- Communication interface: I2C bus
- I2C address: default 0x3C, can be changed using a jumper to address 0x3E, 0x38 or 0x3F
- Measuring range: -40°C to 125°C
- Accuracy: ±0.5°C (-10°C to 60°C)
- Programmable thresholds with interrupt pin
- Programmable operating modes: Freerun, one-shot and Low-ODR
- Supply voltage: 1.5 V to 3.6 V (3.3 V via Qwiic connector)
- Pins: solder pads / 2x Qwiic connectors
- Dimensions: 25.4 x 25.4mm
Kit Contents
- Digital temperature sensor - STTS22H - Qwiic - SparkFun SEN-21262
The address of the I2C bus can be changed with a jumper.
