Product description: MyoWare 2.0 Muscle Sensor Development Kit - kit with medical sensors - SparkFun KIT-21269
The MyoWare 2.0 Muscle Sensor Development Kit includes MyoWare 2.0 ecosystem sensors and accessories that allow you to measure and visualize muscle activity in the human body. Depending on the configuration, you can visualize muscle parameters in action using the MyoWare 2.0 LED Shield display overlay or read the raw values on the analog output using an Arduino-compatible microcontroller. The modules are equipped with snap-on connectors , thanks to which the MyoWare overlays can be stacked. The set also includes biomedical electrodes that can be used for EEG , ECG and EMG examinations (they are disposable and have a layer of latex gel).
Also check the manufacturer's user guide !
MyoWare 2.0 Muscle Sensor Development Kit - kit with medical sensors - SparkFun KIT-21269.
MyoWare 2.0 Ecosystem
The MyoWare 2.0 ecosystem consists of overlays that can be easily combined with muscle sensors and Arduino boards to create a universal electromyography (EMG) sensor. The innovative system of used connectors allows easy snapping of the modules, and the analog TRS Jack 3.5 mm connector is used to connect to the microcontroller, by means of which the raw, filtered and rectified electrical activity of the target muscle is measured. This eliminates the need to solder connections between the boards.
Attention!
MyoWare 2.0 and Cable Shield are not intended to diagnose, cure, mitigate or prevent disease or other conditions in humans or other animals.
Special features of the MyoWare 2.0 Muscle Sensor Development Kit
- Power parameters
- Minimum: 2.27V
- Typical: 3.3 V to 5 V
- Maximum: 5.47V
- Input bias current
- Average: 250pA,
- Maximum: 1nA
- Reverse polarity protection
- Three output modes: Raw EMG, Rectified, Envelope
- Expandable with additional overlays
- MyoWare connectors:
- 3x male snap connector (electrode input)
- 3x female snap-in connectors (power out and EMG Envelope)
- LED indicators: VIN, ENV
- Adjustable gain
MyoWare product range included in the kit.
Kit contents.
Kit contents
- 1x MyoWare 2.0 Muscle Sensor - muscle sensor - version 2.0.4
- 1 x MyoWare 2.0 Power Shield - power shield
- 1x MyoWare 2.0 LED Shield - overlay with LED segment display
- 1 x MyoWare 2.0 Link Shield - MyoWare 2.0 muscle sensor adapter for Arduino
- 1 x 3.5 mm TRS audio cable - 1 m long
- 1 x MyoWare 2.0 Arduino Shield - shield for Arduino
- 1x USB A - USB C cable - 2 m long
- 1x Biomedical electrodes - 10 pcs.
- 1 x MyoWare 2.0 Cable Shield - cap for the EMG sensor cable
- 1 x Leads for biomedical electrodes
- 1x MyoWare 2.0 Reference Cable - connection cable
- 1x Screwdriver
- SparkFun RedBoard Plus - development board compatible with Arduino
