- EOL
|
Attention! The product has been discontinued. Check others products incategory. |
Description
Banana Pi is a minicomputer equipped with 1 GB of RAM, the A20 ARM® Cortex™-A7 Dual-Core 1 GHz processor and the connectors known from the Raspberry Pi, i.a.: 2 x USB, slot forSD card, HDMI, audio Jack. Board also has 40 GPIO pins, as well as communication interfaces: UART, I2C, SPI. Thanks to the SATA connector, the user can connect a drive of up to 2 TB. Built-in buttons: Reset, Power, Uboot and the IR receiver are useful during the operation of the module.
|
An additional advantage of Banana Pi in M1+ version, is a built-in wi-fi module. |
Specification
- Processor: Allwinner A20 ARM Cortex-A7 dual-core, 1 GHz
- RAM: 1 GB DDR3
- Graphics: Mali400MP2
- Built-in wi-fi module
- u.FL slot to connectan external wi-fi antenna
- Slot forSD memory cards
- SATA connector for connecting a 2.5 " drive HDD (in our offer, available is the appropriate cable)
- HDMI connector
- Audio and video Jack of 3.5 mm
- Built-in microphone
- Ethernet port
- 2 USB ports
- 40 pins of GPIO
- Interface for connectinga dedicated camera
- Three built-in buttons: Power, Reset, Uboot
- Built-in IR receiver
- Dimensions: 92 x 60 mm
- Weight: 45 g
Picture and sound
Banana Pi has an HDMI connector, through which you can send picture and sound. In addition, the board were equipped with the jack connector, to which you can connect headphones or led-out the analog video signal.
Operating system
The drive of Banana Pi is amemory card microSD. The operating system can be uploaded via the computer with the reader. Board supports, i.a. systems: Android, Android 4.4, Debian, Ubuntu and Raspbian. Installation guide of the system, can be found atthis address.
Communication
Banana Pi has basic communication interfaces that can be found in office computers of PC class. In addition to the previously listed connectors of audio and video, the user has at his or her disposal:
-
two USB connectors, to which can be connected, for example, a mouse, a keyboard, a wi-fi card or USB flash drive. If you find that the slots are too short, you can increase their number using an external USB HUB.
- Ethernet slot, that is the ability to directly connect to the LAN of 10/100/1000 Mbps.
- the wifi module - Banana Pi M1+ has a built-in wi-fi module with connector for external antenna.
- 40 x GPIO- outputs/inputs with general purpose that can be used to control the LEDs, buttons, drivers of motors. Among them are the pins supporting interfaces: I2C, SPI and UART.
- SATA connector - to connect the drive of up to 2 TB via the appropriate cable.
- the output for the cameraconnector for the camera designed for Banana PI .
Food
As a power source, the system uses the microUSB connector. In practice, this means that to run the Banana Pi, you can use the charger for mobile phones with the capacity of at least 2 A, for example,the power supply Extreme.
Accessories
In our offer, you will find alsoHDMI cables,memory cards, microUSB power supplies andcompatible case.
Photo of minicomputer Banana Pi M1+ in the case.
Useful links |
