- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Specification
- Supply voltage:5 V to 9 V
- Driver L293D
- The number of supported engines: 4
- Maximum current per channel: 600 mA
Description
The module allows you to control four DC motors or two stepper motors using Arduino kits. The system allows you to adjust the direction and speed of rotation of the motors with a current consumption of 600 mA.
Power
When you set the jumper in the 5V position, you can simultaneously power 4 DC motors with a voltage of 5 V. And when setting, the ADJ can supply two motors with voltages ranging from 1.25 V to 6.45 V at the same time (in this case, required is an external power supply of 9 V).
Connection
On the board are:
- External power input: 5 V to 9 V
- Power pins of the input and output
- Interface of the stepper motors
- Interface of DC motors
- Setting M_PWR: connection with 5 V or ADJ
- The switch that selects the power source
- The LED indicating the power
- Linear regulatorAMS1117-ADJ with adjustable output
- The potentiometer for regulating the power of engines
- BridgeL293D
- Built-in linear regulatorLM2596-5.0with output of 5 V
Useful links |
