Description
Wi-fi module based on the ESP8266 chip. It works in wi-fi 802.11 b/g/n standard at 2.4 GHz frequency. It is equipped with 16 pins - pitch of 2 mm, 9 of which are GPIO, 1 ADC and UART. It has the U. FL antenna connector. Board sizes: 17 x 16 mm.
|
In our offer you will also findan adapter that allows you to attach the chip into the breadboard. |
Features of the ESP-07 module
- It has 16 pins:
- 9 x GPIO - digital outputs/inputs
- 1 x ADC input - analog-to-digital converter
- 2 x UART (TX, RX) - for communicating, for example, with Arduino
- Mounting: SMD / THT:
- Hole diameter: 0.9 mm
- Pins pitch: 2 mm
- The default transfer rate of UART communication: 115200 bps
- It is equipped with the U. FL antenna connector
- Dimensions: 17 x 16 mm
Connection
The module has 16 pins, pitch of 2 mm.
| Pin | Description |
|---|---|
| TxD | The transmitter of the serial interface UART. |
| RxD | The receiver of the serial interface UART. |
| GPIO x | GPIO pin (digital output/ input) with a serial number. |
| GPIO 0 | GPIO with special function: To update, you need to indicate the low status (connect to GND). |
| GPIO 15 |
GPIO No. 15 with a special function: In normal and programming mode should indicate the low status (conect to GND). |
| ADC | Input of analog-to-digital converter. |
| REST | The system reset. |
|
EN (CH_PD) |
Power down - indication of low status causes a transition to sleep mode.
To update, you need to indicate a high status (3.3 V). |
| VCC | The power supply is 3.3 V. |
|
The product is compatible with Arduino Instruction of connecting the module with Arduino basing on the module ESP-01, you can find on the blog Majsterkowo and in guide prepared by us.
The board tolerates a voltage of 3.3 V. Therefore, you must choose Arduino operating with the voltage of 3.3 V or use a converter. |
Specification
- Supply voltage: 3.3 V
- Current consumption at rest: approx. 10 µA
- Chip: ESP8266
- Flash memory: 1 MB
- Standard: wi-fi 802.11 b/g/n
- It operates in the 2.4 GHz frequency
- It supports WPA / WPA2 protections
- It can work in AP mode (Access Point), STA mode (standalone) and AP+STA mode
- It supports AT commands
- Communication: UART (Rx, Tx)
- The default UART speed: 115200 bps
- Mounting SMD or THT
- Pins' pitch: 2 mm
- Hole diameter: 0.9 mm
- It has 16 pins, pitch of 2 mm
- 9 x GPIO - digital outputs/inputs
- 1 x ADC input - analog-to-digital converter
- Lua software support
- Board sizes: 17 x 16 mm
