Product description: Feather ESP32-S3 with TFT display - WiFi module, GPIO - 4 MB Flash 2 MB PSRAM - compatible with Arduino - Adafruit 5483
The module from the Feather family, equipped with the ESP32-S3 system and TFT display with a diagonal of 1.14 "and a resolution of 240 x 135 px. It has 4 MB of Flash memory and 2 MB of built-in PSRAM memory . The dual-core Espressif system clocked at 240 is responsible for the correct operation of the board. MHz, is equipped with WiFi and Bluetooth Low Energy communication and has a native USB C-port. The product is used in projects in the field of the Internet of Things (IoT) or broadly understood home automation.
The product is compatible with Arduino!
The manufacturer has prepared a detailed user guide - check it out!
Kit contents.
What is Feather ESP32-S3 TFT?
Feather ESP32-S3 belongs to the family of small modules. It was equipped with an Espressif microcontroller, which supports WiFi and Bluetooth communication with low energy consumption . Its compact dimensions mean that it can be successfully used in projects in the field of, among others. IoT and home automation. Feather ESP32-S3 is based on a dual -core Tensilica 240 MHz processor . It has 4 MB of Flash and 2 MB of PSRAM. In addition, the manufacturer also placed on the board a TFT display with a diagonal of 1.14 "and a resolution of 240 x 135 px, which allows for even greater expansion of projects.
Kit contents
- Feather ESP32-S3 with TFT display - WiFi module, GPIO - 4 MB Flash 2 MB PSRAM - Arduino compatible - Adafruit 5483 - 1 piece
- 1x16 goldpin strip - 2.54 mm raster - for self-soldering - 2 pieces
Basic pinout of Feather ESP-S3
- Pins from A0 to A5 - can be used as analog inputs
- SPI bus:
- SCK: SPI clock line pin
- MOSI: SPI Microcontroller Out / Sensor In
- MISO: SPI Microcontroller In / Sensor Out
- UART interface
- RX: UART receiver pin
- TX: UART transmitter pin
- I2C interface (shared by STEMMA QT connector)
- SCL: clock pin of the I2C bus
- SDA: data pin of the I2C bus
- Digital pins: D5, D6, D9 to D13
Feather module with TFT display.
Feather ESP32-S3 TFT from Adafruit.
Specification of the Feather ESP32-S3 TFT module
- System: dual-core Tensilica 240 MHz
- Flash memory: 4 MB
- PSRAM memory: 2 MB
- Display: TFT with a diagonal of 1.14 "and a resolution of 240 x 135 px
- USB: type C - for programming and power supply
- JST 2-PH connector with Li-Pol battery charger
- LC709203 system monitoring the operation of the battery (when powered by a Li-Pol battery)
- Reset and DFU buttons (BOOT0)
- STEMMA QT connector for I2C devices
- Diodes informing about the status of operation and loading of the module (also support for NeoPixel)
- Low energy consumption up to 100 uA in sleep mode when powered from the battery
- Compatible with Arduino or CircuitPython
- Dimensions: 52.3mm x 22.7mm x 7.2mm
- Weight: 6.3 g
