Product description: Tufts 2040 - board with RP2040 and 2.4 '' TFT LCD display - PiMoroni PIM624
The Tufta 2040 board produced by PiMoroni was based on the microcontroller of the Raspberry Pi foundation - RP2040 Dual-Core ARM Cortex M0 +. Tufty 2040 also has a TFT color LCD screen with a diagonal of 2.4 " and a resolution of 320 x 240 px . On the front of the board there are 5 functional buttons for changing the displayed content or adjusting the brightness of the image. , JST battery connector, STEMMA QT / Qwiic connector, USB type C connector and two buttons - BOOT and PWR.
You can also find the Tufty 2040 plate in our offer with useful accessories - check it out!
Tufts 2040 - Raspberry Pi RP2040 board and 2.4 '' TFT LCD display - PiMoroni PIM624.
Raspberry Pi RP2040 microcontroller.RP2040 microcontroller
The Raspberry Pi RP2040 microcontroller is based on a dual-core ARM Cortex M0 + processor. There is 264 KB of SRAM on board, 30 GPIO pins, including a 12-bit four-channel ADC. One of the more important functions of RP2040 is programmable IO, which can execute custom programs to manipulate GPIO pins. They also allow data transfer between peripheral devices - they can offload tasks that require high data transfer speeds.
Check also other boards with RP2040 microcontroller!
Programming the Tufta 2040 board
The Tufty 2040 board is programmed in C / C ++ or MicroPython. The manufacturer has prepared C ++ and MicroPython libraries along with sample program codes. In addition, it also provides a user guide , which makes it much easier to start working with the board, especially if you are a novice programmer.
Kit contents
- Tufts 2040 - board with RP2040 and 2.4 '' TFT LCD display - PiMoroni PIM624
Tufty 2040 has 5 buttons on the front.
Specification of Tufta 2040
- Display: TFT color LCD
- diagonal: 2.4 "
- resolution: 320 x 240 px
- driver: ST7789v
- Microcontroller system: RP2040 dual-core ARM Cortex M0 + clocked at 133 MHz
- SRAM memory: 264 kB
- Flash memory: 2 MB QSPI with XiP support
- Five buttons located on the front
- Reset and boot buttons located on the back of the board
- White LED
- USB Type-C connector for power and programming
- JST-PH connector (from 3 V to 5.5 V)
- possibility to power with 3x AAA batteries
- possibility to power with Li-Pol or Li-Ion rechargeable battery
- STEMMA QT / Qwiic connector for I2C modules and sensors
