Product description: ATtiny1616 Breakout - extension for Arduino - with connectors - STEMMA QT / Qwiic - Adafruit 5690
ATtiny1616 Breakout is a module manufactured by Adafruit, which acts as a pin expander . It is designed to be used with boards that use the I2C bus , such as Arduino and Raspberry Pi. It extends the functionality of these boards with an additional 12x GPIO, 9x ADC, 5x PWM, 1x NeoPixel, 1x EEPROOM with 127 bytes of NVM memory (the last byte of the EEPROM is used to select the I2C address) and 1x interrupt pin. The module is equipped with the ATtiny1616 microcontroller with 16 kB of Flash memory, 2 kB of RAM and 256 bytes of EEPROM.
ATtiny1616 Breakout - extension for Arduino - with connectors - STEMMA QT / Qwiic - Adafruit 5690.
Product compatible with Arduino and Raspberry Pi!
Before starting work with the module, also check the user's guide prepared by the manufacturer.
ATtiny1616 Breakout.
The interface offered by the board
- 12x GPIO with selectable pullup resistors: 0-5, 6, 8, 11, 14, 15, 16
- 9x 10-bit ADC inputs - pins 0, 1, 2, 3, 4, 5, 14, 15, 16
- 5x 8-bit PWM outputs - pins 0, 1, 7, 11, 16
- 1x NeoPixel output (up to 250 pixels)
- 1x EEPROM with 127 bytes of NVM memory - the last byte of the EEPROM is used to select the I2C address
- 1x interrupt output that can be triggered by any accessories - pin 6
- 2x I2C address selection pin - pins 12 and 13
- 1x LED
Description of board pins
- VIN - power pin (from 2 V to 5 V)
- 3V - power pin (3.3V)
- GND - system ground
- SCL - clock pin of the I2C bus
- SDA - data pin of the I2C bus
Example connection diagram.
Kit Contents.
Module technical specification
- Type: lead expander
- Built-in chip: ATtiny1616
- Flash Memory: 16KB
- RAM memory: 2KB
- EEPROM: 256 bytes
- Oscillator: up to 20MHz
- Built-in 3.3V regulator
- Leads: solder pads, STEMMA QT / Qwiic
Kit contents
- ATtiny1616 Breakout - extension for Arduino - with connectors - STEMMA QT / Qwiic - Adafruit 5690
- Goldpin strip - raster 2.54 mm - 2 pieces
