- EOL
|
Attention! The product has been discontinued. Check others products incategory. |
Description
Uno Plus is compatible with popular moduleArduino Uno. This means that it can be programmed throughthe Arduino IDEusing available libraries. Shields, the so-calledArduino Shields, they will also be collaborating with the module from Waveshare.
The Board contains an ATmega328 microcontroller, it is equipped with 14 digital I/o, 6 of which can be used as PWM outputs (e.g. for motor control), and 6 as analog inputs. The system works with the clock signal with the frequency of 16 MHz. The module has also: a USB connector, DC power socket, RESET button and leads that serve to connect the AVR programmer.
What distinguishes Uno Plus?
| Feature |
Waveshare Uno Plus |
Arduino Uno | Description |
|---|---|---|---|
| The operating voltage of the leads | 5 V / 3.3 V | 5 V | The choice of operating voltage, allows you to connect devices operating at 3.3 V. The change is carried out by jumper. |
| The Reset Button | Pressed from the side | Pressed from the top | The side button facilitates pressing if you installed the Shield. |
| Bootloader Button | Yes | No | |
| USB connector | MicroUSB | USB B | The possibility of using smaller, more popular microUSB cable. |
| Power input | DC low profile |
standard connector |
Low profile of the slot does not interfere with mounting of the plates. |
| Output 3.3 V |
Performance: 800mA |
Performance: 150 mA |
Uno plus provides better performance of the stabilizer 3,3 V. |
| The oscillator | Quartz | Ceramic | The quartz resonator ensures higher precision of timing. |
| Analog inputs | 8 | 6 | |
| The USB driver | FT232 |
ATmega |
|
In order to start Uno Plus, you must connect the system to computer usingmicroUSB cableand choose inthe Arduino IDE, the Arduino Uno board. |
Specification
- Supply voltage: from 7 V to 12 V
- The opportunity to work with a voltage of 3.3 V and 5 V - selection via jumper
- Programmed via USB using a FT232 chip
- Fully compatible withArduino Uno Rev3
- Microcontroller: ATmega328
- Maximum clock frequency: 16 MHz
- SRAM: 2 KB
- Flash memory: 32 KB (5kB reserved for bootloader)
- EEPROM: 1 KB
- I/O Ports: 14
- PWM outputs: 6
- Number of analog inputs: 8 (channels of A/C converter)
- Serial interfaces: UART, SPI, I2C
- External interrupts
- Connector: USB slot (micro usb cablepackage not included)
- Soldered ISP connector
- Power connector: DC 5.5 x 2.1 mm
- Board sizes: 75 x 54 x 15 mm
Useful links |
