List of products by brand SparkFun - Strona 2
CAN-Bus Shield for Arduino - SparkFun DEV-13262
Shield for Arduino supporting the CAN bus, it uses the chip MCP2515 and MCP2551. On board is a connector D-sub, microSD card slot, a connector to attach the display and GPS...Slot sensor - optocoupler GP1A57HRJ00F - SparkFun SEN-09299
Sensor with an infrared emitter on one side and a screen infrared detector on the other. By emitting a beam of infrared light, it can detect when an object passes between the...Logic level converter I2C PCA9306 - SparkFun BOB-15439
The module allows bidirectional communication between circuits using different voltage levels for I2C and SMBus. PCA9306 converts voltages from lower range from 1.2 V to 3.3 V...Keyboard panel 2x2 - compatible with LEDs - SparkFun COM-07836
Overlay for the keyboard with 2x2 - 4 keys. Under each button, you can mount the LED in the through hole case of 3 or 5 mm. It allows you to create panel of keys with the...- Reduced price
- Promotion
Liquid Pump 12V 1325l/h - 3/4'' - SparkFun ROB-10455
350 GPH (1325 LPH) fluid pump. The unit can be fully submerged in water and will not be damaged in the open air. It has 3/4" diameter connectors.Rotation sensor, encoder - 1024 P/R - SparkFun COM-11102
The encoder generates a signal in Gray code which you can interpret using a microcontroller and read the direction and speed of a rotating shaft. The resolution is 1024 pulses...Arcade Concave Button 3,5cm - red - SparkFun COM-09336
Concave button with an outer diameter equal to 35 mm and a height of 65 mm. To the button attached is a simple limit switch.Solenoid Valve 12V - 3/4'' - SparkFun ROB-10456
The device supports control of fluid flow using a computer or microcontroller. The valve is powered by a voltage of 12 V.OpenScale - strain-gauge bridge ATmega328P - SparkFun SEN-13261
Module for measuring the weight and temperature. It is used to read data from the strain-gauge sensors. It allows for calibration, setting the sampling frequency and accuracy....Si4703 development board with FM tuner - SparkFun WRL-12938
The development board with the Si4703 FM tuner. In addition to setting the FM Si4703 station, it can also detect and process radio RDS data, as well as information about radio...RedBoard Qwiic - Arduino compatible - SparkFun DEV-15123
A module made by SparkFun is fully compatible with the Arduino Uno. It has 14 digital input/outputs, 6 PWM channels, 6 analog inputs, as well as popular communication...VCNL4040 - Proximity Sensor Breakout - 20cm (Qwiic) - SparkFun SEN-15177
A digital sensor that combines the ability to measure proximity IR and measure the intensity of ambient light. The module allows to detect obstacles in the range of 0 to 20 cm....Module with USB connector for Raspberry Pi Zero - SparkFun KIT-14526
Overlay equipped with USB connector for Raspberry Pi Zero. Once the overlay is installed on the device it can be connected directly to a computer or HUB without any...Teensy Header Kit - SparkFun PRT-13925
Straps designed for Teensy 3.2 and Teensy LC. They facilitate the use of the module. The kit includes five straps: 2 x 14-pin, 1 x 5-pin, 1 x 3-pin and 1 x 2x7.Female header 1x10 2mm SMD - XBee raster - SparkFun PRT-10030
Single-row strap, female 10 pin. Pitch: 2 mm Mounting: surface SMD. Connector allows you to connect XBee modules.SP485 - UART converter - RS485 - SparkFun BOB-10124
The module converts signals transmitted on the serial UART interface (RX, TX) in the range of the RS485 Protocol that allows you to connect up to 32 devices on one line up to 1...Stepper Motor 42BYGHM809 400 steps 3V 1,7A 0,48Nm - SparkFun ROB-10846
Bipolar stepper motor, four-wire. It has a resolution of 400 steps per revolution (0.9 degrees) . It is powered by 3 V and draws 1.7 A per coil. Holding torque is 4.89 kg*cm...Adapter SSOP to DIP 16-pin - 2pcs - SparkFun BOB-13994
Adapter enables the connection of the chips in SMD SSOP 20 cases to threaded output holes of DIP 16 pin. It also allows you to connect circuits to a breadboard or connect with...TMP102 - I2C temperature sensor - SparkFun SEN-13314
Module with digital TMP102 thermometer in the range from -40 °C to 125 °C, equipped with I2C interface (TWI). The supply voltage ranges from 1.4 V to 3.6 V.Sound detector - microphone with connectors - SparkFun SEN-14262
Audio detector with power voltage range from 3.5 to 5.5 V. The module is easy to use, it has three outputs: analog - to measure the intensity of the signal, digital is...Logic level transmitter TXB0104 bi-directional, 4-channel - SparkFun BOB-11771
The module allows to exchange the data between systems that use the most popular voltage levels: from 1.2 V to 3.6 V for VCCA inputs, and from 1.65 V to 5.5 V for VCCB inputs....Battery Babysitter - LiPo Battery Manager - SparkFun PRT-13777
The module is designed for 1-purpose lithium-polymer batteries. It combines the functions of a charger and a battery monitoring module. It allows to power the system in a safe...EeonTex Conductive Fabric - rigid - SparkFun COM-14110
EeonTex is a durable, conductive fabric. Its resistivity is from 8 Ω / m2 to 108 Ω / m2. Tensile strength is not more than 450 N, the tear resistance is maximally 12 N. The...Thermal imaging camera - FLiR Lepton Dev Kit V2 - SparkFun KIT-15948
A set containing the Flir Lepton V2 thermal imaging camera , and a board to facilitate its connection. The Lepton LWIR radiometric module used in the device has a resolution...- On sale!
- Promotion