Description
The device allows to perform a linear - pulling motion with a voltage signal of 12 V. The range of the bolt is approximately 10 mm. The device has mounting holes with the diameter of 2,5 mm, suitable for screws with the M3 thread. Powering wires with insulation removed at the ends, have a length of approx. 20 cm
|
Attention! The Solenoid consumes a relatively large current so connecting it directly to the pins of the microcontroller will lead to irreversible damage to the system. |
Specification
- Supply voltage: 12 V
- Currsent consumption: approx. 0,4 A
- Wire: 20 cm, without connector
- The range of bolt: 10 mm
- Load: 1 kg
- The bolt has no protection from falling out when the voltage is disconnected
- Mounting holes with the diameter of 2.5 mm with the M3 thread
- Weight: 35 g
Detailed information on the size and power of the device can be found in thedocumentation.
Useful link |
