- On sale!
Description
Module with 32-bit microcontroller with ARM Cortex M4, 180 MHz, 1 MB Flash, 256 kB SRAM. In addition, the board has a 64 MB SRAM. Based on the system STM32F429IGT6. It allows to get acquainted with the system STM32F.
Specification
- Processor STM32F429IGT6:
- Frequency: 180 MHz
- Supply voltage: from 1.8 V to 3.6 V
- Flash memory: 1024 KB
- SRAM: 256 KB
- Communication interfaces:
- 6 x SPI
- 4 x USART
- 4 x UART
- 2 x I2S
- 3 x I2C
- 1 x SAI
- 1 x FMC
- 1 x sdio format
- 2 x CAN
- 1 x LCD display TFT
- 1 x USB 2.0 HS / FS(with dedicated DMA)
- 1 x USB HS ULPI (external PHY is needed)
- 1 x Ethernet 10 / 100
- 1 x camera interface-8 to 14 bits
- 3 x inverter A/C: 12-bit
- 2 x Converter for C/A: 12-bit
- Debugging / programming: supports interface, JTAG / SWD, IAP support
- In addition, on the board there is memory 64 Mbits SRAM
- Reset Button
- miniUSB port (included USB cable - miniUSB)
- Raster: 2 mm
- Dimensions: 83 x 57,50 mm
|
Detailed materials can be found inthe user guide. |
What is on the board?
- Processor STM32F429IGT6
- IS42S16400J: SDRAM, 1 MB x 16 b x 4 banks (64 Mb)
- AMS1117-3.3: voltage regulator 3.3 V
- MIC2075: built-in power management USB
- Power switch: USB or 5VIN contact
- Selection of loading mode: for configuring the BOOT0 contact
- LED indicating the power
- LED VBUS
- RESET button
- Quartz resonator 8 MHz
- Quartz resonator 32.768 kHz for internal RTC with calibration
- Interface JTAG / SWD for debugging and programming
- MiniUSB connector
- Removed pins CPU
- Pin-5VIN: power supply is required when using USB HOST/OTG
- Jumper USB HOST/OTG
- Closed: using USB HOST/OTG
- Open: disconnecting from I/O ports
- VBAT jumper
- Closed: use of system power
- Open: connect the VBAT to external power,such as battery
- VREF jumper
- Closed: connect VREF+ to VCC
- Open: connect VREF+ to the other pins via optional cable
Useful links |
