• EOL

MyoWare 2.0 Power Shield - SparkFun DEV-18427

Index: SPF-21289
MyoWare 2.0 Power Shield is a power shield for modules from the MyoWare 2.0 series. It is equipped with a 3.7 V lithium-ion battery with a capacity of 40 mAh , snap-on connectors, a power switch and a USB type C connector. Thanks to the battery, you can create a mobile device measuring muscle activity in conjunction with the EMG muscle sensor, which can be easily connected with a cover by means of snap connectors . The battery can be charged directly via the USB Type-C port with a current of 40 mA.
MyoWare 2.0 Power Shield - SparkFun DEV-18427
€24.50
€19.92 tax excl.
Unavailable
Discontinued product
PayPal payment
Manufacturer: SparkFun
Compatibility: Arduino

Attention!

The product has been discontinued. Check other products in category.

Product description: MyoWare 2.0 Power Shield - power shield - SparkFun DEV-18427

MyoWare 2.0 Power Shield is a power shield for modules from the MyoWare 2.0 series. It is equipped with a 3.7 V lithium-ion battery with a capacity of 40 mAh , snap-on connectors, a power switch and a USB type C connector. Thanks to the battery, you can create a mobile device measuring muscle activity in conjunction with the EMG muscle sensor , which can be easily connected with a cover by means of snap connectors . The battery can be charged directly via the USB Type-C port with a current of 40 mA. On the board you can also find status LEDs informing about battery charging (CHG, FULL and power supply - VIN).

Warning!
MyoWare 2.0 and Cable Shield are not intended to diagnose, cure, alleviate or prevent disease or other conditions in humans or other animals.

Power overlay for the MyoWare 2.0 ecosystem Power overlay for the MyoWare 2.0 ecosystem.

MyoWare 2.0 ecosystem

The MyoWare 2.0 ecosystem created by Advancer Technologies consists of overlays and sensors equipped with snap-on connectors that allow them to be easily connected with each other, which together with Arduino form a universal tool for studying muscle activity - electromyography (EMG). The innovative system of snap-on connectors allows easy connection of modules, and the analog 3.5 mm TRS jack connector is used to connect to the microcontroller by which the raw, filtered and rectified electrical activity of the target muscle is measured. This eliminates the need to solder the joints between the boards.

The manufacturer has prepared a detailed user guide for the MyoWare 2.0 ecosystem.

Specification of the MyoWare 2.0 power overlay

  • Input voltage: 5V via USB Type-C
  • Output voltage:
    • nominal: 3.7V
    • fully charged: 4.2V
  • Power switch
  • Built-in Li-Pol battery:
    • capacity: 40 mAh
    • nominal voltage: 3.7V
    • maximum charging current: 1C (40 mA)
  • Li-Pol charger system: MCP73831
  • MyoWare Connectors: 3x snap-on connectors
  • LED diodes:
    • VIN
    • FULL
    • CHG
  • Dimensions: 46.15 x 38 mm
Shield with a built-in 3.7 V Li-Pol battery MyoWare 2.0 overlay with a built-in Li-Pol battery.

Package width 5.5 cm
Package height 8 cm
Package depth 1 cm
Package weight 0.007 kg

Be the first to ask a question about this product!

Customers who bought this product also bought:

Products from the same category: