Description
Complete module that allows youto control the brightness of the LED belts or chains by touch or gesture. Works with12 V to 24 V voltageand performance current up to 6 A. It has areverse-polarity-protection, runs on a 8-bit PWM signal. The device requires no configuration, you just need to correctly connect the power supply and the LED belt. The device hasscrew terminal block connectorsfor wire installation. There areself-advesive stripsat the back of the device,which assist the installation of the module.
The device hasscrew terminal block connectorsforwireinstallation. There are self-advesive strips at the back of the device,which assist the installation of the module.
Installation
The module has three screw terminal block connectors, to which you can connect the wires with a screwdriver:
•+supply voltage, shared with the LED indicator.
•GND- system's mass.
•OUT- output control for connecting with the mass of the LED panel.
After connecting to the power supply, for a short time do not place hands, any body parts, or any other conductive objects, as this can affect the calibration process.
Warning! Make sure that the power supply and LED light source complies with the electrical and environmental requirements, and you have a sufficient knowledge to install the device yourself. |
Controlling
-
Approach without touching- temporary mode will turn the lights on for a short time with low power consumption, the light will automatically turn off after a short time
-
Short touch- switch the light on/off
-
Long touch- control the brightness
Specification
- Supply voltage: 12 to 24V
- Maximum current: 6 A
- Operating temperature: 0 to 40 °C
- Protection: reverse-polarity, ESD
- Control signal: 8-bit PWM
- Self-adhesive strips in the rear for attaching the module
- Dimensions: 41 x 51 x 8 mm (18 mm with connector)
Useful links |