|
Attention! The product was replaced by a Polol base for the Sharp digital sensor. |
Description
Using the base, connecting the Sharp GP2Y0D805Z0F(5cm ) and GP2Y0D810Z0F ( 10cm ) sensors comes down to a combination of three outputs: VCC, GND, OUT (output). An LED on the board indicates detection of an object by the sensor.
The base has goldpin leads, which allow to connect the Sharp sensors with the starter kit (e.g. Arduino ) through male/male wires.
Technical specification
- Dimensions: 22 x 9 mm
- The diameter of the hole: 2.4 mm
Supported sensors
- Sharp GP2Y0D805Z0F with object detection at 5 cm distance
- Sharp GP2Y0D810Z0F with 10 cm distance object detection
The system contains passive components according to the Sharp sensor documentation. 
