MinicomputerNanoPi, version Corewith processor Allwinner quad-core ARM Cortex-A7 with a clock frequency of 1.2 GHz. Board has a512 MB of DDR3 RAMand8 GB of memory eMMC,Ethernet Gigabitport on pins of 2.54 mm andmicroUSB slot+3 x USB Hoston pins of 2.54 mm,68 GPIOsand a slot for microSDcards. It works with theuboot, Ambian, DietPi, Lakka, Kali, OpenWrt, etc.
NanoPi works with Debian system. The drive of the device may be the microSD card which can be purchased in our store.
Operating systems can be downloaded from the manufacturer's website.
The manufacturer also provides the guidance for the installation of the system.
The user has at his or her disposal:
- GPIO x 68 pin - outputs/inputs of general purpose that can be used to control the LEDs, buttons, drivers of motors. Among them are the pins that support interfaces: I2C, SPI and UART.
- a slot for microSD - slot for microSD memory cards, on which can be installed the operating system.
As a power source, the system uses the microUSB connector. The manufacturer recommends that the voltage indicated on the plug had a value of 5.0 V and a current of the used adapter shall not be less than 2.0 A. In our offer, you will find power supplies that meet these parameters, for example: power supply Extreme 3.1 A.
The manufacturer has prepared a set of sensors and modules in a convenient chest that simplifies getting started with minicomputer.
The contents of the set Matrix Starter Kit - sold separately.
Quad-Core ARM Cortex A7
uboot, Ambian, DietPi, Lakka, Kali, OpenWrt, etc.
|Clock frequency||1.2 GHz|
512MB of DDR3, 32-bit
8 GB of eMMC
|Slot for GPIO||
68 pins of GPIO
5 V / 2 A - microUSB
|Board sizes||40 x 40 mm|
3 x USB 2.0 on pins of 2.54 mm
|Network interface||Gigabit Ethernet on pins of 2.54 mm|
I/O port (4-pin, contained on pins of 2.54 mm)
UART, SPI, I2C, GPIO
The serial port on pins of 2.54 mm
2x goldpin 24-pin strip / 2.54 mm
1x goldpin 20-pin strip / 2.54 mm