- EOL
|
Attention! The sale of the product has been completed. Check others in thiscategory. |
Description
The device is designed for tactile switching on and off and dimming ofLED strip and LED striplighting. The module is mounted to the furniture board.
Connection .
- Solder the leads to the LED lighting to the connector marked with LED.
- Solder the 12 / 24 V DC power supply cables to the connector marked with the power symbol.
- Check the correct connections.
|
Note The device works best with Class 2 power supplies. If the device is powered from a lower class power supply unit with a PE wire (yellow-green), minus (-) should be connected with the PE wire of the power supply unit and / or with the PE wire of the mains system. Otherwise, the system may not react to touch, or react in a limited range and with much lower sensitivity. If there is no response to touch, or in the case of self-brightening, disconnect the power supply for 30 seconds and reconnect. |
Specification
- Power supply voltage: 12 V DC
- Output voltage: 12 V DC
- Power: 60 W
- Maximum current: 5 A
- Degree of protection: IP40
- Operating range: 10 to 30 mm
