- New
List of products by brand Iduino - Strona 2
Loading...
Flame sensor - 760-1100nm - Iduino SE060
The sensor used to detect fire. It is powered with the voltage from 3.3 V to 5 V. The range of the detected wave is from 760 nm to 1100 nm, detection angle is 60 °. The...
Index: OST-14255
Index: OST-14255
Module with the touch button built into the mosaic of the PCB. It is powered with the voltage of 5 V with the digital output signal.
Index: OST-14269
Index: OST-14269
Temperature sensor - thermistor NTC-MF52 - Iduino ST1147
Module with temperature sensor equipped with a thermistor NTC-MF52. In order to read values from the sensor, connect it to the analog signal of the microcontroller. It detects...
Index: OST-14322
Index: OST-14322
Expansion Kit - extension Raspberry Pi to breadboard + tape + breadboard - Iduino RA028
A module that allows the GPIO Raspberry Pi pins to be led out onto the contact plate using IDC tape. The kit also includes a contact plate and 40-pin tape.
Index: OST-14267
Index: OST-14267
Distance sensor, reflective 3,3V/5V - Iduino ST1140
The module is equipped with IR reflective sensor equipped with digital output. It works with a supply voltage from 3.3 V to 5 V. It is applied in the robots tracking the line.
Index: OST-14274
Index: OST-14274
Screw Shield v3 - screw connectors for Arduino - Iduino EX027
Overlay consisting of two boards bringing out all Arduino pins on screw connectors, to which you can connect a wire with a screwdriver. Additionally there are analog and...
Index: OST-14327
Index: OST-14327
RF522 RC522 13,56MHz SPI + card and keyring - red - Iduino ME138
Board allows you to read and save data from RFID devices at 13.56 MHz frequency. The module is based on the RC522 system, it is powered with the voltage of 3.3 V,...
Index: GRL-10574
Index: GRL-10574
Water Level Sensor Module - Iduino SE045
The sensor is used for determining liquid level in the vessel. It is powered by a voltage of 5.0 V. The output is an analog voltage which increases its value along the depth...
Index: MOD-07279
Index: MOD-07279
Hit sensor + wire - Iduino SE024
Hit sensor, the signal of which, after a collision with some object, goes into high status. It has a status LED that informs about changing the status of voltage. It works with...
Index: OST-14254
Index: OST-14254
Module with photoresistor + cable - analog - Iduino ST1107
Module with photoresistor for Arduino. It can be used to measure the intensity of light. It is controlled via an analog signal, is powered with the voltage of 5 V. The set...
Index: OST-14301
Index: OST-14301
Heartbeat Detection Sensor - Iduino SE049
A sensor that allows you to measure your pulse with your finger using a phototransistor. The red LED lights up each time it detects a pulse. Powered by 5 V.
Index: OST-14276
Index: OST-14276
940nm infrared transmitter - Iduino ST1087
Module with IR transmitter, works with a voltage of 5 V.
Index: GRL-12509
Index: GRL-12509
Vibration sensor - Iduino SE053
A simple vibration sensor with digital output. It is powered with the voltage of 5 V. It has a 3-pin connector.
Index: OST-14324
Index: OST-14324