- EOL
|
Attention! The sale of the product has been completed. Check otherdevices in this category. |
Description
MEMS type sensor dedicated for Raspberry Pi version B and B+ and Freescale module FRDM-KL25Z. It has built-in sensors: accelerometer MMA8491, compass MAG3110 and altimeter (pressure gauge) with thermometer MAG3110. The system communicates via I2C bus.
The system has a 2x13 pin connector, which enables direct connection of the device in GPIO Raspberry Pi.
|
The description of the outputs and the module diagram are available in the user guide. |
|
According to the manufacturer's information, at the moment there are no drivers available for Raspberry Pi 2, the device works properly with Raspberry Pi version B and B+. |
Specification
- Power supply: 3.3 V from Raspberry pins Pi
- Built-in sensors:
- Pressure and height: MPL3115 (documentation):
- range: 50 kPa to 110 kPa
- resolution:
- pressure[Pa]and height[m]: 20 bits,
- temperature[°C]: 12 bits
- programmable interrupts
- communication: I2C
- Accelerometer: MMA8491Q (documentation):
- number of axles: 3 - X, Y, Z
- scope: ±8 g
- resolution: 14-bit
- sensitivity: 1 mg/LSB
- communication: I2C
- Magnetometer: MAG3110 (documentation):
-
- scope: ±1000 μT
- sensitivity: 0,1 μT
- communication: I2C
- Communication: I2C bus
Useful links
|
