- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: Motor Control Board L293D - 36 V / 0.6 A motor controller
The module allows you to control two DC motors or one stepper motor at a time. The system allows you to adjust the direction of rotation of motors with current consumption up to 600 mA and supply voltage up to 36 V.
|
Product compatible with Arduino The manufacturer has prepared a user guide with asample program for Arduino and STM32. |
Exits
The device has a 6-pin goldpin connector and 6 screw connectors.
| Pin | Description |
|---|---|
| VCC | Power supply voltage: 5 V. |
| GND | The weight of the system. |
| M1B/M1A | Check the direction of rotation of the first engine. |
| M2B/M2A | Check the direction of rotation of the other engine. |
|
Screw connections + / - |
Motor supply voltage. |
|
Screw connection M1 / M2 |
Outputs to connect the motor poles. |
|
Jumper |
Allows you to select the motor supply voltage. VCC and + from the screw connector are available. |
Module Truth Table
|
M1A/M2A |
M1B/M2B |
M1/M2 |
|---|---|---|
|
state |
state low |
Contrary to the instructions / Clockwise |
| state low |
state high |
As directed by the instructions / Opposite to the clockwork |
| state high |
state high |
Detained |
| state low |
state low |
Detained |
Specification
- Module supply voltage: 5 V
- Operation of motors with voltages from 4.5 V to 36 V
- Controller: L293D(documentation)
- No PWM signal output
- Number of engines supported: 2
- Maximum current per channel: 600 mA
Useful links |
