- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: RedBoard Artemis ATP - compatible with Arduino - SparkFun DEV-15442
Redboard Artemis ATP(All the Pins) board created bySparkFunhas48 GPIO pins compatible withArduino Mega. The module is based onArtemis Apollo3chip. RedBoard Artemis ATP can be programmed in Arduino IDE environment viaUSB type Cconnector. The board has 1 MB of flash memory and 384 kB of RAM. The Artemis chip runs at 48 MHz and 96 MHz in turbo mode and has the ability to communicate viaBluetooth. The GPIO pins include popular communication interfaces such as I2C, I2S, SPI, UART, PWM, ADC, PDM and digital and analog I/O. The board also features a MEMS microphone and the ability to measure current consumption.
RedBoard Artemis ATP board.
RedBoard Artemis ATP similar to Arduino Mega
The board is based on the popular Arduino Mega module, but uses a different chip - Artemis Apollo3. The chip features clockingup to 96 MHz,1 MB of flash memoryand384 kB of RAM. On 48 GPIO pins you can find 31 PWM channels, 10 14-bit ADC channels, 2 differential ADC channels, 2 UART, 6 I2C lines, 6 SPI lines, PDM interface, I2S interface, "Smart Card" interface and Bluetooth LE communication. There is also aQwiicconnector on the board for simple connection of accessories with the same connector. Programming is done with built-inCH340Cconverter usingUSB Cconnector, for this purpose you can use Arduino IDE environment. The board can be powered from DC jack with voltage from7 V to 15 V, from USB C with voltage of5 Vor optionally withCR2032 battery. The board'sI/O pins operate at 3.3 V. There is also a debugging socket on the board.
More information about the board can be found in the manufacturer'suser guide.
| Specification RedBoard Artemis ATP | |
|---|---|
| Supply voltage | 7 V to 16 V |
| Logic voltage | 3,3 V |
| Chip | Artemis Apollo3 |
| Compatible with | Arduino Mega |
| Power supply | DC Jack, USB C, CR2030 battery (optional) |
| USB to UART converter | CH340C |
| Chip clocking | 48 MHz / 96 MHz in turbo mode |
| Flash memory | 1 MB |
| RAM | 384 kB |
| Number of GPIOs | 48 |
| Interfaces |
31 x PWM 10 x ADC 14-bit 2 x ADC differential 2 x UART 6 x I2C 6 x SPI 2 / 4 / 8 - bit SPI PDM i2S "Smart Card" |
| Communication | Bluetooth Low Energy - BLE |
| Connectors |
Qwiic USB C debugging port DC jack 5.5 / 2.1 |
| Microphone | MEMS |
