- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: SparkFun Qwiic Pro Kit - development kit - SparkFun KIT-15349
Qwiic Pro Kit development kit from SparkFun. It includes the RedBoard Turbo board, a module with a proximity sensor and a 3-axis accelerometer , connecting cables with a Qwiic connector, as well as a module with a joystick and a compact micro OLED display. All elements of the set use the I2C communication interface via the Qwiic connector. The RedBoard Turbo board uses the ATSAMD21G18 chip with a 32-bit ARM Cortex M0 + microcontroller, which can operate at a frequency of up to 48 MHz.
The manufacturer provides a detailed user guide that will help you fully use the potential and capabilities of SparkFun Qwiic Pro Kit. Check!
SparkFun Qwiic Pro Kit contents.
Kit contents
- RedBoard Turbo - compatible with Arduino - SparkFun DEV-14812
- Connecting cable USB type A - USB type - 0.8 m long
- Module with joystick - SparkFun COM-15168
- MMA8452Q - 3-axis I2C accelerometer - Qwiic - SparkFun SEN-14587
- VCNL4040 - proximity sensor - 20 cm (Qwiic) - SparkFun SEN-15177
- Module with Micro OLED display - SparkFun LCD-14532
- Qwiic flexible cable with 4-pin plug - 5cm - SparkFun PRT-17260
- Qwiic flexible cable with 4-pin plug - 10cm - SparkFun PRT-17259
- Qwiic flexible cable with 4-pin plug - 20cm - SparkFun PRT-17258
- Qwiic flexible cable with 4-pin plug - 50cm - SparkFun PRT-17257
RedBoard Turbo - Arduino compatible board
The SparkFun RedBoard Turbo board is an excellent alternative to modules with an Arduino-derived microcontroller. It is economical and efficient and can be used for programming embedded systems. It has a 32-bit ARM Cortex M0 + microcontroller and a built-in UD2 bootloader (USB Flashing Format). The module has as much as 4 MB of Flash memory, 32 KB of SRAM and 32 KB of EEPROM memory.
Technical specification of RedBoard Turbo
- Microcontroller: ATSAMD21G18
- CPU: ARM Cortex-M0 +
- Fully compatible with Arduino Uno Rev3
- Supply voltage: 3.5 V to 6 V
- Programming: via USB using FTDI
- Flash memory: 4 MB
- SRAM memory: 32 kB
- EEPROM memory: 32 kB
- I / O Ports: 14
- PWM outputs: 6
- Analog inputs: 6
- Serial interfaces: UART, SPI
SparkFun RedBoard Turbo.
