Description
Shield for Arduinowith dual-channel DC motordriver operating with a voltage of 5 V to 26 V and current up to 2 A, based on the L298P circuit. The board has jumpers for selecting the control mode and a strip connector with reflective sensorsLSS05.
Layout of the board
- Reset button for the Arduino main board
- Connector ARK for connecting motors
- Connector ARK for connecting external power supply
- LED PWR
- Jumper to select power source (external / Arduino)
- Protection circuit against reverse polarity in external power supply
- L298P motor driver system
- Jumper for selecting the mode of control
- Test switches - when pressed, the current will pass from output A to B or from B to A and motor will be spinning clockwise or in the opposite direction, depending on the connection.
- Connector for a strip with reflective sensors LSS05
- I/O Arduino
Specification
- Driver system: L298P
- Supply voltage: 5 V to 26 V
- Maximum current per channel: 2 A
- Logic levels voltage: 3.3 V and 5 V
- Protection against reverse polarity
- Connector for a strip with reflective sensors LSS05
- Maximum PWM frequency: 10 KHz
- Sizes: 68, 55 mm
Useful links |
